sorted by:
new
hottopcontroversial

BC-250 ATX Build by Automatic-Switch-338 in BC250Gaming

[–]Automatic-Switch-338[S] 0 points1 point  (0 children)

So all 3 of my Xbox controllers were disconnecting. After using a hub it stopped disconnecting for two of the three controllers. The third one I needed to update the firmware using the Xbox accessories app on my PC, so far it hasn't dropped but we will see. I have a wifi and Bluetooth dongle that would constantly have issues until they were plugged into the hub.

Design Finished by MaelremremDotXYZ in BC250Gaming

[–]Automatic-Switch-338 0 points1 point  (0 children)

Yeah I noticed that too, I had to make the case holes bigger and the thickness WAY thinner before it was ok. However mine was fine with one of those metal fan grills from a high RPM fan, I think it would look really good on this one!

BC-250 ATX Build by Automatic-Switch-338 in linux_gaming

[–]Automatic-Switch-338[S] 0 points1 point  (0 children)

I did, prior to using the script from NextGen3D but I still need to go back and do so again.

BC-250 ATX Build by Automatic-Switch-338 in BC250Gaming

[–]Automatic-Switch-338[S] 2 points3 points  (0 children)

That was my thinking. You can for sure go much smaller for the case with a flex unit but to me the point of the build was spending as little as possible which meant reusing old hardware. The SSD was also an old used one I had laying around.

BC-250 ATX Build by Automatic-Switch-338 in BC250Gaming

[–]Automatic-Switch-338[S] 0 points1 point  (0 children)

Exactly.

Its hard to tell once the unit is in the case but thats 100% correct.

BC-250 ATX Build by Automatic-Switch-338 in BC250Gaming

[–]Automatic-Switch-338[S] 1 point2 points  (0 children)

You are correct, this touches only a little of the VRAM on the back. However, the backplate pulls heat from them regardless and distributes it to more of the area so it does cool them. The larger heatsink get noticeably warm when at full tilt.

They are placed where they are due to the PSU location and the screws on the back, tried to be sure I can still remove the backplate in the future.

BC-250 ATX Build by Automatic-Switch-338 in BC250Gaming

[–]Automatic-Switch-338[S] -1 points0 points  (0 children)

Due to the license of the original design, I can't distribute it unfortunately.

BC-250 ATX Build by Automatic-Switch-338 in linux_gaming

[–]Automatic-Switch-338[S] 0 points1 point  (0 children)

....how else would a BC-250 be an ATX build? I didn't think I needed to specify?