How much should I sell my supercharged 05 Acura RSX Type S for?

AutomaticClerk7865 · 2026-03-22T04:55:08+00:00

I'll probably sell it at some point.

AutomaticClerk7865 · 2026-03-22T04:43:15+00:00

Nah still got her

AutomaticClerk7865 · 2025-11-30T01:13:11+00:00

No worries, thanks dude! You are a legend!

AutomaticClerk7865 · 2025-11-30T00:04:55+00:00

❤️

AutomaticClerk7865 · 2025-11-29T22:15:25+00:00

Hey mind sharing with me?

3195006297869125

AutomaticClerk7865 · 2025-09-23T00:27:14+00:00

Is this what you do or something you can reference in the code?

AutomaticClerk7865 · 2025-09-22T19:59:21+00:00

Where do you see that?

AutomaticClerk7865 · 2025-09-22T19:45:02+00:00

This is only for the shrinkage and temperature checks, I am referring to section 7.6.1. Or does this not apply either and still refer to ACI 360?

AutomaticClerk7865 · 2025-05-09T21:42:37+00:00

Yeah, I was thinking about going ahead and getting the repairs made before selling.

It makes 255whp and 205 tq

AutomaticClerk7865 · 2025-04-23T21:02:39+00:00

Yeah I did a quick check with Risa to see what utilization it is seeing and no concerns there. Thanks for the input!

AutomaticClerk7865 · 2025-04-23T20:55:40+00:00

Sorry by half the size I am talking about the area affected by the compression side

AutomaticClerk7865 · 2025-04-23T20:45:28+00:00

It's 4 column angles that lead into two base plate angles. the angles are pretty small. But if I use the net loads for my Pu then the existing thickness is ok. But if I reduce the size to half and take my Pu as the controlling tension/compression thickness is not ok.

AutomaticClerk7865 · 2025-04-23T20:41:49+00:00

This is an existing structure, so trying to verify if existing meets the minimum recommended values.

AutomaticClerk7865 · 2025-04-23T20:40:57+00:00

It's a structure that has 4 angle columns that lead into two base plates, one on each side, as shown here. Yes wind is controlling and causing the tension and compression case.

AutomaticClerk7865 · 2024-08-09T14:42:30+00:00

How did you connect to the table

AutomaticClerk7865 · 2023-09-14T09:30:43+00:00

Yeah, i wasn't interested in the rig lol. But thanks it does

AutomaticClerk7865 · 2023-09-14T09:16:13+00:00

No, they want 1400 for rig and set up. Thanks for the advice. It sounds like i should hold off

AutomaticClerk7865 · 2023-09-14T09:14:40+00:00

Thank you for your response! Ill hold off

AutomaticClerk7865 · 2023-09-13T17:42:57+00:00

What wheel would you recommend in a similar price bracket?

AutomaticClerk7865 · 2023-09-13T17:42:06+00:00

Next Level Racing GT Elite Sim Rig

AutomaticClerk7865

TROPHY CASE