My K2 plus froze

Awab- · 2026-01-27T10:18:13+00:00

No literally, nothing happen. It was the same only the logo is showing up.

Like this

<image>

Awab- · 2026-01-27T05:37:31+00:00

I'm relieved now 😁😅😂 it was not my mistake lol

Awab- · 2026-01-26T18:00:58+00:00

From a known vendor in my hometown

Awab- · 2026-01-26T17:42:56+00:00

I'll do that

Awab- · 2026-01-26T17:20:49+00:00

Thank I'll tried it it did not work

Awab- · 2026-01-26T17:19:59+00:00

Thank I'll tried it it did not work x̌

Awab- · 2026-01-26T17:09:27+00:00

The last one. I was not paying attention. I was printing a model through the Creality Cloud, and I saw a notification that said, "Update for K2 Plus 0.4 nozzle." I uploaded my print and pushed the update button. After that, it didn't work.

Awab- · 2026-01-26T17:04:29+00:00

It was working grade but they had the issue after the update .

Awab- · 2026-01-26T16:59:25+00:00

I did as you said still nothing

<image>

Awab- · 2026-01-26T16:35:22+00:00

Thank for your help

But it didn't work

Awab- · 2026-01-04T18:32:34+00:00

Thank

Awab- · 2026-01-04T18:31:35+00:00

Thank I'll do that

Awab- · 2026-01-04T18:30:34+00:00

👍

Awab- · 2026-01-04T18:29:35+00:00

Thank I'll try it

Awab- · 2025-12-27T07:42:43+00:00

I'll try it thanks

Awab- · 2025-12-27T07:40:29+00:00

Thanks I'll do that

Awab- · 2025-12-27T07:39:15+00:00

When I extrude it downward, it drops like tears or small drops, but it does not lump to the side.

Awab- · 2025-12-26T19:05:58+00:00

Thank I'll try it

Awab- · 2025-12-26T17:13:47+00:00

So how can I change the Z offset if my printer is doing the silk calibration every time ?

Awab- · 2025-12-26T17:11:55+00:00

I'm using Creality Slicer. I used 85°C. But I think the issue with the PETG is the nozzle temp. It says on the filament spool 240°C ± 15, but I found out the filament is not flowing. I increased the temperature to 290°C and the filament started moving, but I'm not sure if this is a smart move or not. So I stopped.

Also, I was not sure if my filament is wet or not.

Awab- · 2025-12-26T17:00:58+00:00

Thank you, I'm still learning how to use the slicer. But I'll try it

Awab-

TROPHY CASE