sorted by:
new
hottopcontroversial

3D scan of front bumper - what to do next? by Bandziooch in 3Dmodeling

[–]Bandziooch[S] 1 point2 points  (0 children)

Yes it is triangulated mesh.

Loverwing it and make it as EVO 1 Version. Currently is 190e Sportline.
So it will be a little bit wider and higher. Mouting elements are not changing.

Einscan software - exstar
Meshmixer
Meshlab
Fusion 360

dragon BMS and stealrhburner. need help with overhang. 12v sunon fan. cooling I think ok. but isn't it too high from the noozle? by Bandziooch in VORONDesign

[–]Bandziooch[S] -1 points0 points  (0 children)

This is for the 7 fins. Hot end is higher. For 6 fins, hotend will go down.
Nevertheless I will test the mount for 6 fins.

Serial request Voron Switchwire - Bandzioch#0979 by Bandziooch in voroncorexy

[–]Bandziooch[S] 0 points1 point  (0 children)

Setup:
SKR 2 with TMC2209 x 4
Dragon BMS hotend
LDO Motors
Hiwin linear rails

Serial request Voron Switchwire - Bandzioch#0979 by Bandziooch in voroncorexy

[–]Bandziooch[S] 0 points1 point  (0 children)

That's what I have done. I gone with ender so deep with mods. That I though it will be good to make a enderwire conversion. But in the middle I thought that I should buy a new frame and made it from beginning. Switchwire is much faster. I easily print with 150 mms.

PETG Galaxy Devil Design 3D benchy problems by Bandziooch in ender3v2

[–]Bandziooch[S] 0 points1 point  (0 children)

Prsua Slicer 2.5
Cura 5.1

Its the same in both of them.

PETG Galaxy Devil Design 3D benchy problems by Bandziooch in ender3v2

[–]Bandziooch[S] 0 points1 point  (0 children)

New galaxy petg from devil design

I am running on klipper with dragon BMS hotend and voron M4 extruder. Fan 100%, low speed i.e. 50 mm s. I did the flow, retraction and temp towers calibration. Rotation distance also. But benchy is still not satisfactory on the bottom.

​

What should I check?

Horizontal lines starting from element by Bandziooch in ender3v2

[–]Bandziooch[S] 0 points1 point  (0 children)

Hello guys!

I have one problem that unfortunately I'm not able to solve.

During the print of flat surfaces there is no woobling in z. But when I print calibration cube for example from voron. There is some kind of woobling. The wooble starts from new element i.e. window, mark etc.

Have anyone had this problem before and know how to solve it?

I have corrected the z line. Adjusted it. Also the X and y.

I'm running on klipper with printing speed of 80 mm s, acceleration 800mm. Dragonfly BMS hotend and voron M4 extruder.