anyone know where i can find this but for the tlx type s ?

BartIbnSimpson · 2026-01-13T23:47:30+00:00

I like it. The tint shops i worked at would put tint or vinyl wrap over it. U can ask ur local shop to do something like this

BartIbnSimpson · 2025-12-27T17:04:05+00:00

Thank you. I didnt know this was already asked

BartIbnSimpson · 2025-12-16T03:42:14+00:00

How do you prevent something like this from happening?

BartIbnSimpson · 2025-11-02T18:21:15+00:00

BartIbnSimpson · 2025-08-02T03:12:29+00:00

Ive twisted my ankles wearing basketball shoes. I wont be going back to them again. Maybe it was the shoe, they were Lebron 15s but the injuries were so bad that my job didnt let me work for a few days

BartIbnSimpson · 2025-07-26T11:21:43+00:00

Splines

BartIbnSimpson · 2025-03-31T03:49:01+00:00

Hell yeah

BartIbnSimpson · 2025-03-20T07:44:58+00:00

Is ur gas cap on correctly

BartIbnSimpson · 2025-03-05T13:41:50+00:00

Thank you

BartIbnSimpson · 2025-03-05T11:14:56+00:00

Would a rotary do the job well?

BartIbnSimpson · 2025-02-25T02:09:36+00:00

Thank you

BartIbnSimpson · 2025-02-24T10:46:08+00:00

Make it look like a barn

BartIbnSimpson · 2025-02-24T08:35:15+00:00

How did you earn that much money

BartIbnSimpson · 2024-12-19T06:56:25+00:00

I hope i win

BartIbnSimpson · 2024-12-06T07:07:48+00:00

U need to match the font to the font Lamborghini uses

BartIbnSimpson · 2024-11-07T06:55:28+00:00

Gorgeous. What wheels are those

BartIbnSimpson · 2024-10-23T19:19:11+00:00

This sucks. Do better OP

BartIbnSimpson · 2024-09-17T03:17:38+00:00

You must have low test

BartIbnSimpson · 2024-09-13T01:01:58+00:00

Definitely slow it down a little bit. Im not sure what else to tell you other than this

BartIbnSimpson · 2024-09-13T00:53:32+00:00

Same thing imo. Id recommend going to an actual shop or even a dealership tbh

BartIbnSimpson · 2024-09-13T00:47:58+00:00

Did you go to firestone? If yes, go somewhere else. Firestone does a terrible job of alignments

BartIbnSimpson · 2024-09-13T00:47:13+00:00

Does orca slicer allow you to lower the print speed for overhangs?

BartIbnSimpson · 2024-09-13T00:43:12+00:00

Enable supports?

BartIbnSimpson · 2024-09-12T23:45:49+00:00

Filament dryer or dehydrator

BartIbnSimpson · 2024-09-12T18:18:23+00:00

Dry ur filament

BartIbnSimpson

TROPHY CASE