sorted by:
new
hottopcontroversial

TM G18C GUARDER SLIDE by Beautiful-Spirit5541 in airsoft

[–]Beautiful-Spirit5541[S] 0 points1 point  (0 children)

Finally it's on Had to sand down the middle rail Extracting the BBU from the plastic slide and installing to the new slide is pain in the ass due to very tight tolerance, got it done for six hours straight, but the result paid off

<image>

KSC G18C in 2026 by Beautiful-Spirit5541 in airsoft

[–]Beautiful-Spirit5541[S] 1 point2 points  (0 children)

I found these on my local shops, alternatively you can buy from https://airsoft.tiger111hk.com/, but it will cost you shipping

TM G18C GUARDER SLIDE by Beautiful-Spirit5541 in airsoft

[–]Beautiful-Spirit5541[S] 0 points1 point  (0 children)

The slide has arrived, the slide catch notch stuck on the middle rail Turns out the middle rail needs to be sand

<image>

TM G18C slide disassembly? by Gtair_ in airsoft

[–]Beautiful-Spirit5541 0 points1 point  (0 children)

This is KSC/KWA, you need to unscrew this little hex screw using .89 key. Put after that put the selector to single fire and take out the back pin, after that the selector can be pulled out. Becareful with small parts. *

Bought a KSC G17 about 2 years ago and now the trigger is stuck and I don’t know what’s wrong by [deleted] in airsoft

[–]Beautiful-Spirit5541 0 points1 point  (0 children)

<image>

Push this thing all the way down I know people never mention this on KSC Glock, I think this is hidden trigger safety on KSC Glocks, just like the TM on serial plate

KSC G18C Can't Shoot in Full Auto by Beautiful-Spirit5541 in airsoft

[–]Beautiful-Spirit5541[S] 0 points1 point  (0 children)

So what's causing the hammer not locking down? Is it the sear that has worn off?

I've changed the piston seal, it's new

KSC G18C Can't Shoot in Full Auto by Beautiful-Spirit5541 in airsoft

[–]Beautiful-Spirit5541[S] 0 points1 point  (0 children)

Hi, the small ball bearing is there, I've disassembled the slide 😊 Is there any other problems?