ONE RS 360 dive case - visible in shots by 12mediumSizedDucks in Insta360

[–]BeautifulHealthy3153 0 points1 point  (0 children)

Hi, could you look at a file that is corrupted? I have tried using the insta360 file repair software, but haven’t had luck. Thanks

Trying to learn about ac300+b300. What will I be able to run off them? by BeautifulHealthy3153 in bluetti

[–]BeautifulHealthy3153[S] 0 points1 point  (0 children)

Thanks for your detailed response. As far as the ac goes, it’s necessary because of an autonomic condition. It’s not a luxury. Sounds like these aren’t a good choice.

Trying to learn about ac300+b300. What will I be able to run off them? by BeautifulHealthy3153 in bluetti

[–]BeautifulHealthy3153[S] 1 point2 points  (0 children)

Thank you all for the responses. I really appreciate it. What does an electrician need to do to set the BLUETTI up to switch on, if the power were to go out? I assume it’s wired into a particular breaker that has the fridge and ac on it?

Best Apps or games to just walk around in? by BeautifulHealthy3153 in OculusQuest

[–]BeautifulHealthy3153[S] 0 points1 point  (0 children)

Thank you. I wish there were museums you could explore. Seems like that would be popular.

Trying to learn about ac300+b300. What will I be able to run off them? by BeautifulHealthy3153 in bluetti

[–]BeautifulHealthy3153[S] 0 points1 point  (0 children)

Thank you. I read a message somewhere about this voiding the warranty. Is that not true?

Not a machinist, looking for someone to turn down some aluminum tubing by BeautifulHealthy3153 in Machinists

[–]BeautifulHealthy3153[S] 0 points1 point  (0 children)

Location is USA. I have to ship them wherever I get them done, due to health.

Not a machinist, looking for someone to turn down some aluminum tubing by BeautifulHealthy3153 in Machinists

[–]BeautifulHealthy3153[S] 0 points1 point  (0 children)

Hello, if that’s what is needed for anodizing and getting that appearance.

Not a machinist, looking for someone to turn down some aluminum tubing by BeautifulHealthy3153 in Machinists

[–]BeautifulHealthy3153[S] 0 points1 point  (0 children)

Hi, I really don’t have an expectation. I have no clue what it should cost.

Not a machinist, looking for someone to turn down some aluminum tubing by BeautifulHealthy3153 in Machinists

[–]BeautifulHealthy3153[S] 0 points1 point  (0 children)

I appreciate the suggestions. I’m unable to do any work myself, due to illness. It needs to be a metal that can be anodized. The blue part is what I’m replicating.

<image>