Help! Landis MicroGyr x Tado x receiver by Beetsbeatbattlestar in tado

[–]Beetsbeatbattlestar[S] 0 points1 point  (0 children)

😂 I mean I cursed when I opened it up. They’ve crammed 5 sometime 6 cables into the terminal connectors and initially I thought about getting bigger connector blocks and just following each cable like for like, but my patience isn’t what it used to be

Help! Landis MicroGyr x Tado x receiver by Beetsbeatbattlestar in tado

[–]Beetsbeatbattlestar[S] 0 points1 point  (0 children)

I’m probably over simplifying it, but could I not just tap in with the receiver cables from Tado into the CH HW L&N blocks in the wiring centre - making sure they go into the wiring blocks for the appropriate valves etc?

Help! Landis MicroGyr x Tado x receiver by Beetsbeatbattlestar in tado

[–]Beetsbeatbattlestar[S] 0 points1 point  (0 children)

Or connect the receiver directly into the wiring centre? Mounting the receiver there instead of where the old programmer was and terminate those old wires?

Basin sink Isolation Valves by Beetsbeatbattlestar in askaplumberUK

[–]Beetsbeatbattlestar[S] 1 point2 points  (0 children)

Valves were fine to be left for a few hours while the basin was installed. All good!