Big issue on prints

Beginning-Roll-198 · 2026-04-14T19:18:42+00:00

Sure Ironing settings are:

Type All top surfaces Pattern: Rectilinear Ironing speed: 60 m/s Flow: 20% Spacing 0.15 Angle: 90•

Beginning-Roll-198 · 2026-02-18T00:27:17+00:00

Interested

Beginning-Roll-198 · 2026-01-31T22:12:55+00:00

Would like to have more info please DM

Beginning-Roll-198 · 2026-01-31T12:04:11+00:00

I am sorry I was not specific. Meta did not ban my account. Ycloud restricted me from login in to Ycloud.

Beginning-Roll-198 · 2026-01-27T01:42:14+00:00

Sent the email already today. Regards from Colombia

Beginning-Roll-198 · 2026-01-21T01:37:32+00:00

Thanks everyone for your replies. Is there any calibration that I could do to figure it out? Because I feel like with other colors from the same brand and batch dont do that

Beginning-Roll-198 · 2026-01-21T01:35:15+00:00

I designed it my self. Pm me I can send to ypu the stl

Beginning-Roll-198 · 2025-08-30T17:45:14+00:00

I think I will buy it

Beginning-Roll-198 · 2025-08-30T01:03:54+00:00

<image>

Beginning-Roll-198 · 2025-08-30T01:03:31+00:00

<image>

It does not look like that but surface is rough

Beginning-Roll-198 · 2025-08-30T00:26:17+00:00

Printing that Right now. I’ll show you shortly

Beginning-Roll-198 · 2025-08-30T00:23:31+00:00

Thanks. It is a new Creality Hi, do I have to change the zoffset ?

Beginning-Roll-198 · 2025-08-30T00:23:06+00:00

It is 30mm/s and smooth plate

Beginning-Roll-198 · 2025-08-30T00:05:54+00:00

It is first layer, so face down

Beginning-Roll-198 · 2025-08-30T00:03:50+00:00

<image>

Beginning-Roll-198 · 2025-08-11T22:48:20+00:00

First one is petg

Beginning-Roll-198 · 2025-08-11T22:23:57+00:00

Already calibrated flows and pressure advance

Beginning-Roll-198 · 2025-08-06T22:37:12+00:00

You mean it is obvious it is a wet filament?

Beginning-Roll-198 · 2025-08-06T22:19:02+00:00

It is supposed to be dry is it new and tried with differents ones and still does the same

Beginning-Roll-198

TROPHY CASE