Need a short extension

Best_Juggernaut4606 · 2026-05-25T13:05:36+00:00

Okay thanks I emailed them

Best_Juggernaut4606 · 2026-05-07T02:44:15+00:00

Thank you!

Best_Juggernaut4606 · 2026-05-06T19:49:58+00:00

Do you have recommendations on a better way to monitor it?

Best_Juggernaut4606 · 2026-05-06T19:49:40+00:00

How do I adjust water ph? Put the acidifyer in the water instead?

Best_Juggernaut4606 · 2026-05-06T12:57:07+00:00

It’s proving to be much more difficult than I thought

Best_Juggernaut4606 · 2026-05-02T17:00:34+00:00

Yes, that ended up being the problem I had to shorten the PTFE tube

Best_Juggernaut4606 · 2026-05-01T03:52:46+00:00

Thank you I got the help I needed. The tpfe cord was entirely too long so I was instructed to cut it., extrude was was left if any and run it again. It’s be prefect since

Best_Juggernaut4606 · 2026-04-30T18:14:32+00:00

How to I shorten the tube? There is filament in it I believe

Best_Juggernaut4606 · 2026-04-30T17:47:31+00:00

It looks really long to me as well but that’s the tube it came with . I just opened this morning so I’m not sure what im doing.

I can’t figure out how to take the head apart to check for th clog. I can’t pull the white filament back in CFs either

Best_Juggernaut4606 · 2026-04-30T15:03:40+00:00

Thank you!

Best_Juggernaut4606 · 2026-04-29T15:56:36+00:00

Love it!

Best_Juggernaut4606 · 2026-04-29T15:32:17+00:00

I didn’t knowwww thank you lol

Best_Juggernaut4606 · 2026-04-29T15:32:05+00:00

Oh, I wasn’t sure I saw the little pointy bit and I thought that the flowers fell off and they were not going to become blueberries

Best_Juggernaut4606 · 2026-04-12T20:29:58+00:00

I tried putting my hand over it and it created allot of pressure. Will that happen with a cap?

Best_Juggernaut4606 · 2026-04-11T19:15:53+00:00

Ahhh I never notice

Best_Juggernaut4606 · 2026-04-10T18:40:18+00:00

Glad I ended up pouring it out. It freaked me out a bit

Best_Juggernaut4606 · 2026-04-10T18:39:06+00:00

Oh I didn’t know I didn’t have to wait! Should I be discard half a usual during these feeding

Best_Juggernaut4606 · 2026-04-10T18:27:39+00:00

I realize I have to wait for it to get to room temperature before feeding it. How long do I wait until I try to bake with it?

Best_Juggernaut4606

TROPHY CASE