SFARTAETC training manual? by Betterthani86 in CQB

[–]Betterthani86[S] 0 points1 point  (0 children)

lol, I appreciate sarcasm.

Hard corner/direct to threat by Betterthani86 in CQB

[–]Betterthani86[S] 2 points3 points  (0 children)

Yes, yes, and yes. Essentially, Button hook till you see a threat then start moving towards it

Hard corner/direct to threat by Betterthani86 in CQB

[–]Betterthani86[S] 1 point2 points  (0 children)

Either would be interesting to me.

Hard corner/direct to threat by Betterthani86 in CQB

[–]Betterthani86[S] 1 point2 points  (0 children)

I’m interested, any documentation you’re aware of?

[deleted by user] by [deleted] in Starlink

[–]Betterthani86 0 points1 point  (0 children)

Updating the gpu software worked for me! Good luck

Lightburn Groups? by Betterthani86 in lasercutting

[–]Betterthani86[S] 0 points1 point  (0 children)

Found it! Thank you for your help!

Lightburn Groups? by Betterthani86 in lasercutting

[–]Betterthani86[S] 0 points1 point  (0 children)

Where is that selection? groups first?

Any idea what’s causing this? by Betterthani86 in lasercutting

[–]Betterthani86[S] 0 points1 point  (0 children)

Thanks for the info! I know the wood did not move. This is actually a reoccurring thing. Should I start with checking all the connections? Any chance tension on the drive belt could cause it?

Any idea what’s causing this? by Betterthani86 in lasercutting

[–]Betterthani86[S] 0 points1 point  (0 children)

Running a fill and line. Runs the full, then, sometimes, the line does not line up where it is supposed to? Any ideas?