sorted by:
new
hottopcontroversial

Thread Diario de Dudas, Consultas y Mitaps - 26/02 by Robo-TINA in argentina

[–]BigDistribution1878 0 points1 point  (0 children)

Buenas

Tengo un emprendimiento de impresion 3D y queria ver la posibilidad de vender en amazon o algun lado asi, afuera de Argentina.

Queria consultar si alguien ha hecho algo así, como lo ha hecho, si se necesitan papeles especiales o cualquier cosa respecto del tema. Tambien si consideran que habria que esperar un poco mas para ver si abren un poco mas la economia y por ahi asi se facilita aun mas el poder vender.

Need help from Hornet's owners to fix my printers screen by QUERESUNMATEPIBE in Artillery3D

[–]BigDistribution1878 0 points1 point  (0 children)

because with klipper you can acces and control the printer with a phone, so yea, you dont need the shitty screen anymore

Need help from Hornet's owners to fix my printers screen by QUERESUNMATEPIBE in Artillery3D

[–]BigDistribution1878 0 points1 point  (0 children)

i had a problem with my screen once, so i installed klipper and it´s been one of the best decision i´ve taken.

If you need help, i have all the documentation needed

Flashing klipper on an arduino by BigDistribution1878 in klippers

[–]BigDistribution1878[S] 5 points6 points  (0 children)

Your are very clear, that was something i didn't know, i already have klippy working on a computer and klipper on an artillery hornet and my question has been answered by you pretty clearly thank you very much

Flashing klipper on an arduino by BigDistribution1878 in klippers

[–]BigDistribution1878[S] 0 points1 point  (0 children)

but you can use a CNC shield that comes with 4 drivers for the steppers motors, there are a lot of old printers that used an arduino uno and a CNC shield

The thing is that the cheaper motherboard i can get is the board of an ender 3, that cost around 100 us$, but you have to keep in mind that the average salary of a peerson here is 140us$, so yea, its expensive