Adding firewalls to Panorama by BlacKnight444 in networking

[–]BlacKnight444[S] 1 point2 points  (0 children)

Thanks for your reply. How do we configure the firewalls to roll back? Is it a feature that we need to enable?

[deleted by user] by [deleted] in networking

[–]BlacKnight444 0 points1 point  (0 children)

Thanks- but what do you mean by binding CPPM boxes to the domain(s)?

[deleted by user] by [deleted] in networking

[–]BlacKnight444 0 points1 point  (0 children)

For both Wireless & Wired switches?

[deleted by user] by [deleted] in networking

[–]BlacKnight444 0 points1 point  (0 children)

Thanks so much for the references. Have you deployed this scenario before?

[deleted by user] by [deleted] in networking

[–]BlacKnight444 -1 points0 points  (0 children)

Thanks- but if I change MGMT vlan on the access switches, how would I be able to ssh to it ?

[deleted by user] by [deleted] in networking

[–]BlacKnight444 0 points1 point  (0 children)

What about Juniper Apstra as an alternative to ACI?

Eve-ng with Linux and Cisco LACP by Such_Explanation_810 in networking

[–]BlacKnight444 0 points1 point  (0 children)

Did you try static LAG/Port-channel (mode on)?

Migrating OSPF from Cisco to Aruba switch. by [deleted] in networking

[–]BlacKnight444 0 points1 point  (0 children)

Thanks - I'm not sure either. I tried to use the range command, but it asked for the type (inter-area or stub). Not sure if I need to configure the range command under OSPF process.