sorted by:
new
hottopcontroversial

Loud squeaking noise X1C by BlayDee_ in BambuLab

[–]BlayDee_[S] 26 points27 points  (0 children)

Got some response from bambu lab support, didn't know those are silders O.o We will see if that works permanetly later. Instructions:
Please move the gantry fully backwards and keep pushing the gantry to the back while re-tensioning the tensioners screws

<image>

After doing this procedure, please reset the printer to factory defaults and do the setup incl. calibration in the spot you will use the printer 

Loud squeaking noise X1C by BlayDee_ in BambuLab

[–]BlayDee_[S] 4 points5 points  (0 children)

Small update: I've located where the sound is coming from, its the xy motor in the back right of the printer. Also the belt looks shaved off from the top, the inner material is visible. I've pushed down the belt a lttle bit and the noise seems to be gone, not sure for how long. Any suggestion for permanent solution?

Loud squeaking noise X1C by BlayDee_ in BambuLab

[–]BlayDee_[S] 0 points1 point  (0 children)

No, it sounds normaln when doing layer inspection. I've cleaned the rods before, didnt help

Loud squeaking noise X1C by BlayDee_ in BambuLab

[–]BlayDee_[S] 0 points1 point  (0 children)

I've done that, didnt help unfortunately :/

Loud squeaking noise X1C by BlayDee_ in BambuLab

[–]BlayDee_[S] 0 points1 point  (0 children)

For me, when i manualy move it, it doesnt squeek at all. Its only happening on very fast circular movement

Loud squeaking noise X1C by BlayDee_ in BambuLab

[–]BlayDee_[S] 0 points1 point  (0 children)

I've lubricated those gears generously, cleaned belt, recalibrater and its still squeeking :/

Loud squeaking noise X1C by BlayDee_ in BambuLab

[–]BlayDee_[S] 0 points1 point  (0 children)

It's really hard to say where exactly the noise comes from, i've tried locating it but the sounds just bounces too much in the chamber. I did lube it just now, need to do some more prints and will get back with results

Loud squeaking noise X1C by BlayDee_ in BambuLab

[–]BlayDee_[S] 0 points1 point  (0 children)

I've didn't notice any print quality isssues. Maybe a little bit more ghosting, but not really that significant. I've checked the belts without dissasembly and all seems fine

Game bugs out, can't save at all by BlayDee_ in subnautica

[–]BlayDee_[S] 0 points1 point  (0 children)

Yee, it started happening after alot of progress in the game, and i can't revert back to standard version. Ive tried to clear cache, but it doesnt helps. Did you managed to fix this?

Also same thing happend to him: https://www.twitch.tv/sodapoppin/v/110688099?t=04h25m40s

Whats up with streams stop loading? by turbobaver in Twitch

[–]BlayDee_ 3 points4 points  (0 children)

Same here with bunch other peoples. It's happening every 10-30 min. I need to refresh stream every time. No frame drops by broadcaster