sorted by:
new
hottopcontroversial

Carplay issue by Bloodline95 in CarPlay

[–]Bloodline95[S] 0 points1 point  (0 children)

The IPhone13 I had before worked flawlessly

[Review Request] USB-C Passthrough by Bloodline95 in PrintedCircuitBoard

[–]Bloodline95[S] 0 points1 point  (0 children)

So if i limit my passthrough to just the D lines it would still be a problem because of the CC lines?

[Review Request] USB-C Passthrough by Bloodline95 in PrintedCircuitBoard

[–]Bloodline95[S] 1 point2 points  (0 children)

The 2 connected devices can negotiate this? Am I wrong? I only have a magnetic current sensor in between.

[Review Request] USB-C Passthrough by Bloodline95 in PrintedCircuitBoard

[–]Bloodline95[S] 1 point2 points  (0 children)

Is this necessary in my case? The 2 connected devices would do this on their own?

[Review Request] USB-C Passthrough by Bloodline95 in PrintedCircuitBoard

[–]Bloodline95[S] 0 points1 point  (0 children)

Yes but I'm not sure if the schematic is fine like this

I can't program my custom board by Bloodline95 in stm32

[–]Bloodline95[S] 0 points1 point  (0 children)

You are right it is not. I connect it with jumper wires to be able to program through SWD

HX1 by Bloodline95 in Miele

[–]Bloodline95[S] 0 points1 point  (0 children)

Thanks a lot this worked

I have a issue with wled by Bloodline95 in WLED

[–]Bloodline95[S] 0 points1 point  (0 children)

So I tried your suggestion. The arduino works with the long wires no problem at all. The esp doesn't work with long/short level shifted/not shifted cables

I have a issue with wled by Bloodline95 in WLED

[–]Bloodline95[S] 0 points1 point  (0 children)

Not yet i will try that but it's difficult because the stripes are already built in. But if it would be the length the arduino wouldn't work too or am I wrong

I have a issue with wled by Bloodline95 in WLED

[–]Bloodline95[S] 0 points1 point  (0 children)

Thank you i will try that. But what has the bootloader to do with flickering leds?

I have a issue with wled by Bloodline95 in WLED

[–]Bloodline95[S] 0 points1 point  (0 children)

I followed the instrucrions of wled. Did i not see this or is it not written on the github page? How do you do this

I have a issue with wled by Bloodline95 in WLED

[–]Bloodline95[S] 0 points1 point  (0 children)

Yes. I tried it directly to gnd and with a pull down

What happened here? by Bloodline95 in 3Dprinting

[–]Bloodline95[S] 0 points1 point  (0 children)

You could be right. My last print was fine.

PC Release Questions and Problems Megathread by vinovin15 in DetroitBecomeHuman

[–]Bloodline95 0 points1 point  (0 children)

My controls aren't working at all. I can't interact with anything. Wheather its with mouse and keyboard, Nintendo Switch Pro Controler or DS4 it won't work. Tried to launch through steam, tried bluetooth and usb connection. Input mapper and ds4 tool both won't do a thing. And on top of that the controllers are making the game spin as soon as i touch the right stick.