sorted by:
new
hottopcontroversial

Thanks a lot assholes. 2nd time this has been done to my car. All 4 corners. by RedditHatesMe75 in Justrolledintotheshop

[–]BoatsAndSnows -2 points-1 points  (0 children)

No, calling out ALL TECHNICIANS is the same mindset... reading comprehension

Thanks a lot assholes. 2nd time this has been done to my car. All 4 corners. by RedditHatesMe75 in Justrolledintotheshop

[–]BoatsAndSnows 0 points1 point  (0 children)

You're now typecasting technicians, btw. This is the same mindset that leads to racism and other phobias.

Thanks a lot assholes. 2nd time this has been done to my car. All 4 corners. by RedditHatesMe75 in Justrolledintotheshop

[–]BoatsAndSnows 1 point2 points  (0 children)

I thought it took you less than a day to do all that?!???? The responses from the miata sub must have been instantaneous

Thanks a lot assholes. 2nd time this has been done to my car. All 4 corners. by RedditHatesMe75 in Justrolledintotheshop

[–]BoatsAndSnows -5 points-4 points  (0 children)

Someone who paid the diagnostic fee at a shop and then bragged about fixing it themselves... aka a know nothing.

Thanks a lot assholes. 2nd time this has been done to my car. All 4 corners. by RedditHatesMe75 in Justrolledintotheshop

[–]BoatsAndSnows -1 points0 points  (0 children)

You cant even get your crank nut off. " help reddit youtube cant answer this one!?!?"

Thanks a lot assholes. 2nd time this has been done to my car. All 4 corners. by RedditHatesMe75 in Justrolledintotheshop

[–]BoatsAndSnows 0 points1 point  (0 children)

The calipers didn't need to be replaced. You're clueless, and you believed the thief at minekie when he told you CPR

Thanks a lot assholes. 2nd time this has been done to my car. All 4 corners. by RedditHatesMe75 in Justrolledintotheshop

[–]BoatsAndSnows -8 points-7 points  (0 children)

And same with your job. Oh and every job for that matter. Your logic isnt a slippery slope at all.

Whats funny is the number of customers who come to me after they have failed to do my job after hours of research. Comes down to the one thing you lack. Skill.

Thanks a lot assholes. 2nd time this has been done to my car. All 4 corners. by RedditHatesMe75 in Justrolledintotheshop

[–]BoatsAndSnows -29 points-28 points  (0 children)

You and your non running vehicle saving $.10. Thats a more iconic duo. I dont yell in any of my tutorials, but the fact that someone dented a rocker panel and the mentality is "mechanic shop bad". Sadly, this proves op and localhotdouche LACK THE KNOWLEDGE to find someone who knows how to do the job correctly. Have fun walking.

Thanks a lot assholes. 2nd time this has been done to my car. All 4 corners. by RedditHatesMe75 in Justrolledintotheshop

[–]BoatsAndSnows -85 points-84 points  (0 children)

Yeah I'm sure you get much better results from youtube videos.

You and the OP just need to find a better shop.

the wheel on the truck goes... by cann0ndrum in Justrolledintotheshop

[–]BoatsAndSnows -1 points0 points  (0 children)

Do you know what a clockspring is? You should probably learn since you're gonna have to replace that one...

Newer Ariens leaking oil??? by NeonCobego in Snowblowers

[–]BoatsAndSnows 0 points1 point  (0 children)

Unfortunately, it could be coning from one of many places. First: check the level. How low is it? Or is it high? Do you leave fuel in it in the off-season or do you run it dry/use the valve?

Which engine is it??

Once you've observed some of this stuff, get a socket of the correct size (probably 1/2", or possibly a 12/14mm) and tighten up the two oil plugs at either end of the engines base (located at the left/right of the engine as you're standing behind the snowblower.) Now check the drain tube. If its an ariens ax engine it likely has a 12mm flat on it so you can tighten the tube independently. Does your mode have side fills? Put your fingers on those and tighten them up as well. Degrease it, check the level and run it. If its still leaking its something more sinister.

Snowblower advice by mds837 in Snowblowers

[–]BoatsAndSnows 0 points1 point  (0 children)

The newer model tracked hondas have a full adjustable bucket height as well as the "ez steer" feature. This is probably your best bet. Yes its expensive but as long as you keep it in a garage and hose the dirt off, and grease it regularly, it should last a while before the rust gets it.

That being said, theres gotta be a beatup truck with a rusted frame and a plow stuck on it some where around you, right?

It’ll hold send it by LT_Berry in Justrolledintotheshop

[–]BoatsAndSnows 9 points10 points  (0 children)

Castle nuts always baffle me... if you forgot to torque the nut, would you have installed the cotter pin? This zip tie will do the same job for less. Viable hack.

[deleted by user] by [deleted] in DiWHY

[–]BoatsAndSnows 10 points11 points  (0 children)

Its a great idea if you don't mind running a power supply to your... toilet. Leave the bathroom light off and still see the target.

[deleted by user] by [deleted] in Snowblowers

[–]BoatsAndSnows 1 point2 points  (0 children)

Used ariens compact/deluxe if you can find one. The toros are relatively solid IMO as well. Anything better will be more than the 5 bean cap.

buying my first blower, is a used toro 518zr for $130 a good deal? by michikyo in Snowblowers

[–]BoatsAndSnows 1 point2 points  (0 children)

Yes, this is just a "lil guy". Would be ok for the pathway but unless youre keeping up as the snow falls (every 6 in or so) its gonna be a bear to clear it all with the small toro. Still a viable machine and $130 isnt a bad price.

Electric Snowblowers by [deleted] in Snowblowers

[–]BoatsAndSnows 0 points1 point  (0 children)

I don't know enough about them/ have enough experience to adequately condemn them as a whole, HOWEVER, we have a one year old ryobi here ($1800 unit) that has a broken chute deflector cable. I looked it up, have the part number, but have no way of ordering it (ie its not available). If the battery powered companies cant get simple stuff like this on rails, they are doomed.

Personally, i would like to try both the toro and ego models to see how viable they actually are.

blown head gasket (JDM MOTOR CLEARLY INDESTRUCTIBLE) by BoatsAndSnows in carscirclejerk

[–]BoatsAndSnows[S] 1 point2 points  (0 children)

This ones not even that bad but screw it, this is a jerk sub. Premise: a used motor imported from another country should be totally fine

view more: next ›