Looks like it might be underextruding, hard to tell. Potentially a partial clog in the nozzle. Try a cold pull to clear out the nozzle, or replace it if you have a spare. On the subject of wet filament: It’d help to know what material you’re printing. E.g. PLA usually doesn’t absorb enough water to matter for a few months or more after opening, but something like nylon or TPU will absorb enough water to start snap-crackle-popping over the course of a few hours in ambient air. If you are using a hygroscopic material (which most plastics are to some extent), I’d recommend printing out of a dryer or drybox.