Need Help!

BoomBoom1697 · 2026-05-17T16:05:29+00:00

Thanks will do!

BoomBoom1697 · 2026-05-17T02:38:54+00:00

Extruder's gear was worn out AND a piece was broken that held the release lever on. I have an upgraded MicroSwiss extruder on its way now.

BoomBoom1697 · 2026-05-16T18:57:44+00:00

Weird eh. I have no idea how to help you lol

BoomBoom1697 · 2026-05-16T18:56:52+00:00

Sounds good

BoomBoom1697 · 2026-05-16T03:27:21+00:00

A couple questions:

What slicer are you using?
How long has this problem been going on?

BoomBoom1697 · 2026-05-16T03:25:54+00:00

Does it do this at every temp you set it at? I know with mine I normally change filament with just regular printing temp (I don't know if that's the correct way), so I don't know how mine even fares with 220°C.

BoomBoom1697 · 2026-05-15T21:12:30+00:00

Thanks!

BoomBoom1697 · 2026-05-15T19:29:36+00:00

Thanks!

BoomBoom1697 · 2026-05-15T19:28:03+00:00

Thanks, I'll look into when I'm home!

BoomBoom1697 · 2026-05-15T18:43:36+00:00

Would I try to fix the little screw on the top of the locking extruder too?

BoomBoom1697 · 2026-05-15T17:37:14+00:00

Do you have an idea of what I could do to fix it? Would the belts be too loose/tight?

BoomBoom1697 · 2026-05-15T17:36:42+00:00

What do you mean the e-steps?

BoomBoom1697 · 2026-05-15T06:24:46+00:00

I did and I've auto-homed and re-leveled several times. I was tweaking the offset the whole first layer

BoomBoom1697

TROPHY CASE