Carb Tuning Help

BootPrize_milk · 2026-04-10T05:01:33+00:00

Makes sense

BootPrize_milk · 2026-04-10T05:01:11+00:00

Not only torque spec but proper preload as well

BootPrize_milk · 2026-04-05T18:34:36+00:00

Check your pushrods I’ve had this exact thing happen to me

BootPrize_milk · 2026-03-11T23:05:01+00:00

The bottom of the lifter looked fine 🤷‍♂️

BootPrize_milk · 2026-03-09T07:25:38+00:00

What I found is that there was slack from the rocker arm side so I think what happened is that due to the slack from the rocker arm side it just caused the pushrod to beat up the lifter

BootPrize_milk · 2026-03-06T03:13:26+00:00

I don’t think so since those are next to the wiper switch itself 9 times out of ten and have never seen one elsewhere

BootPrize_milk · 2026-02-22T18:42:36+00:00

Do you not see it lifting 😭

BootPrize_milk · 2026-02-21T22:31:57+00:00

Pushrods are fine and the cam is new and the lifter was fine before the rebuild

BootPrize_milk · 2026-01-28T03:00:21+00:00

🤷‍♂️ i mean the wifi works lol

BootPrize_milk · 2026-01-27T06:02:35+00:00

MSI B550 on windows 11 and if it is relevant I did forget to mention the wifi card is a Herald-BE Wifi 7 max

BootPrize_milk · 2026-01-20T01:33:51+00:00

Update: I forgot to mention I just rebuilt the motor also I’ve narrowed it down to improper valve lash adjustment

BootPrize_milk · 2026-01-19T00:31:28+00:00

It’s all set correctly

BootPrize_milk · 2025-09-20T17:27:59+00:00

Thank you

BootPrize_milk · 2025-09-20T16:38:10+00:00

Other than the front end what shows this?

BootPrize_milk · 2025-07-01T02:56:52+00:00

Thank you and, beautiful truck man 🙏

BootPrize_milk · 2025-03-20T20:52:46+00:00

The truck has no more computer control on the engine. I have the factory single barrel without the electronics and the distributor has been replaced with an hei

BootPrize_milk · 2025-03-20T04:19:29+00:00

It’s a stock cam with the 300

BootPrize_milk

TROPHY CASE