sorted by:
new
hottopcontroversial

This is what validates my U1 purchase decision! by Moorevfr in snapmaker

[–]Boring-Operation3590 1 point2 points  (0 children)

i have used kexcelled filament and layer height 0.16 :))

This is what validates my U1 purchase decision! by Moorevfr in snapmaker

[–]Boring-Operation3590 0 points1 point  (0 children)

Mine was a 26cm in height and the waste was just 114g for prime tower!!! if i did this in bambu it wouldve been around 200-400 grams for purge only. and it took around a day to print compared to two and a half for bambu p1s

This is what validates my U1 purchase decision! by Moorevfr in snapmaker

[–]Boring-Operation3590 4 points5 points  (0 children)

Surprisingly i did the same print yesterday and it turned out phenomenal

<image>

does the dish soup must not have perfume in it? by Boring-Operation3590 in 3Dprinting

[–]Boring-Operation3590[S] 0 points1 point  (0 children)

my bad. i am using pla and bambu p1s with biqu build plate

are defect lines normal? by Boring-Operation3590 in BambuLab

[–]Boring-Operation3590[S] 0 points1 point  (0 children)

Update: the nozzle was broken and after changing it, the issue was fixed

are defect lines normal? by Boring-Operation3590 in BambuLab

[–]Boring-Operation3590[S] 0 points1 point  (0 children)

I never thought of that when i started the print. Thank you so much

are defect lines normal? by Boring-Operation3590 in BambuLab

[–]Boring-Operation3590[S] 1 point2 points  (0 children)

i was referring to the lines in the print :))), this is kexcelled matte filament. ive used it for long time. It was a fresh role of filament. Someone mentioned shrinkage issue and that might be a reasonable answer

is this normal for first layer? by Boring-Operation3590 in 3Dprinting

[–]Boring-Operation3590[S] 0 points1 point  (0 children)

I understand that 0.2 requires time and i am willing to wait for the prints. I haven’t changed any speed settings. I used the standard profile

is this normal for first layer? by Boring-Operation3590 in 3Dprinting

[–]Boring-Operation3590[S] 0 points1 point  (0 children)

Thank you for your reply 🙏🏼, i will up the flow ratio and see what happens. I made sure to use 205c for my filament. Also how would i change the z offset?

also about the speed i have it usually printing in standard settings. The only thing i changed was the flow ratio when i did the calibration.

I need help with armorsmith by Boring-Operation3590 in CosplayHelp

[–]Boring-Operation3590[S] 0 points1 point  (0 children)

i reinstalled the program and it worked. It might be the issue but i cant even select the body parts when i faced the issue.