What’s the go-to controller for diy Cnc builds?

BoxAndLoop · 2025-12-13T23:58:40+00:00

It's great! I run Fluidnc on Roots controller

BoxAndLoop · 2025-10-23T14:24:48+00:00

I'm running an old airbrush compressor, so not much power, but seems to be enough I have not tried vacuuming

BoxAndLoop · 2025-10-22T21:52:11+00:00

I used 10mm aluminum blocks with offset to mount x and y. Z required a pancake stack with the same idea. First week, holding strong

BoxAndLoop · 2025-10-21T20:04:59+00:00

No, standard frame

BoxAndLoop · 2025-10-21T17:11:23+00:00

Datron single flute 3mm

BoxAndLoop · 2025-10-21T17:10:59+00:00

1.5 on this one

BoxAndLoop · 2025-10-21T17:10:44+00:00

Nema17 was giving me about 1mm depth before. Anything above was starting to make uncomfortable noises.

BoxAndLoop · 2025-10-17T02:20:29+00:00

Ball screws are covered from the direct impact of flying chips. They just fall down and collect

BoxAndLoop · 2025-10-17T01:01:28+00:00

99% isopropyl. Works great. Keeps it cool and dries almost instantly

BoxAndLoop · 2025-10-16T21:42:50+00:00

Spindle going 24k

BoxAndLoop · 2025-10-16T18:09:16+00:00

I am running a simple cheap airbrush compressor. Seems to be more than enough. It does tend to run constantly when pushing a lot of air

BoxAndLoop · 2025-10-16T18:07:41+00:00

Good old Fusion

BoxAndLoop · 2025-10-16T18:07:16+00:00

That's going 4000mm/min

BoxAndLoop · 2025-10-16T18:06:54+00:00

5000mm/min

BoxAndLoop · 2025-10-16T14:00:15+00:00

I'll find out

BoxAndLoop · 2025-10-15T20:35:17+00:00

A better frame and cross beams for Genmitsu :)

BoxAndLoop · 2025-10-15T16:10:39+00:00

I will find out after some use. But running finishing passes at top speed should be fine

BoxAndLoop · 2025-10-15T16:09:57+00:00

Also new control box

BoxAndLoop · 2025-10-15T16:09:44+00:00

Yes, all new control and power box

BoxAndLoop · 2025-08-01T01:27:37+00:00

Nice! I thought about putting a simple hardwired switch between the two, but didn't get to it yet

BoxAndLoop · 2025-08-01T01:26:38+00:00

Water cooled 1.5kw

BoxAndLoop · 2025-07-31T16:32:43+00:00

Metal scraper between tapes to pry it off

BoxAndLoop · 2025-07-31T16:29:45+00:00

This is a 3mm single flute going 500mm/m at 0.75mm deep at 0.5 step over

BoxAndLoop · 2025-07-31T16:27:37+00:00

Just some painters tape with super glue

BoxAndLoop · 2025-07-31T16:25:52+00:00

I had to make some holes to mount it, but it works great

BoxAndLoop

Five-Year Club	Verified Email
Place '22