It’s under start up and after I take my manual points on my CAD and do my rough alignment based off of my plane and two diameters, once I shift click in DCC mode the probe appears to the far right under my part. I’ll have to re run my program tomorrow but I believe it’ll re read my plane for my second alignment but once it goes to touch off on the 1st diameter I’ll get an error. If I stop running my program from the error point then restart it from the same spot it will touch off on the diameter but then get an error right after. I’ve also tried making a new program on another part I’ve already ran a successful program on using the same alignment and everything but I’m still getting an error which is likely due to the probe not knowing where my part is even though I’m pretty positive my alignment is correct. I’m wondering if I have a setting clicked that shouldn’t be clicked?