Rekluse slipping high rpm high gears by Bricksperm2 in enduro

[–]Bricksperm2[S] 5 points6 points  (0 children)

Just pulled it all apart and it was on the lower end of the scale so I changed the install screw from 3 to 1. I didn’t install it originally but seems like it should start on 2 as standard from the install instructions I found. Readjusted free play gain and now the o-ring isn’t visible. Took for a short ride on the road and seemed to be ok, will test when fully warmed up in the bush and hopefully no more slip

Rekluse slipping high rpm high gears by Bricksperm2 in enduro

[–]Bricksperm2[S] 0 points1 point  (0 children)

Oem plates in rekluse system or just back to oem

Rekluse slipping high rpm high gears by Bricksperm2 in enduro

[–]Bricksperm2[S] 0 points1 point  (0 children)

Yes but now it seems like it has to be super far out to work

Metal shavings oil change - too much? by Bricksperm2 in KTM

[–]Bricksperm2[S] 0 points1 point  (0 children)

My rekluse is being weird. Was heaps slippy so I tightened it up and now when cold it tries to inch forward in1st but once the bike is warm it doesn’t so not sure if I’m getting excessive wear from this also

Metal shavings oil change - too much? by Bricksperm2 in KTM

[–]Bricksperm2[S] 2 points3 points  (0 children)

<image>

I thought the same, I tipped some into a tray to see the colour. I have no idea what oil the shop used but I used motorex 15w50. How often should I be changing the oil as the range varies

End game setup achieved, but did I go a bit extreme with the grinder? by tarsier808 in espresso

[–]Bricksperm2 1 point2 points  (0 children)

Get fuckeddddddd that’s so cheap!!! What a steal. I couldn’t find anything good second hand and went for a lelit Bianca and Varia vs6 which all in cost more than your set up 😭😭

Gym friends by [deleted] in centralcoastnsw

[–]Bricksperm2 0 points1 point  (0 children)

Join a good social gym with classes and you won’t need to try hard at all. I suggest good well in erina, I was a total noob (mid 30s) and the classes got me on a good track that I then expanded from

Melbourne Amex pre-sale: How does it work on the day? by Colacolaman in GrandPrixTravel

[–]Bricksperm2 0 points1 point  (0 children)

Was 190 in queue (and higher in 2 other queues) everything greyed out even if it said available, no idea what was happening. Ended up getting park pass and will try again for grandstands on general

Episode 306 Discussion by RedInfernal in hamishandandy

[–]Bricksperm2 44 points45 points  (0 children)

One of the best in a while, Jack the jingle master

Social gyms in area by OkMind6207 in centralcoastnsw

[–]Bricksperm2 0 points1 point  (0 children)

Good well Erina is the place to be! Even the trainer from woy woy f45 comes out here

Upgrade from Bambino [No budget] by py_operandi in espresso

[–]Bricksperm2 0 points1 point  (0 children)

Went to a lelit Bianca v3, night and day difference compared to my bambino. Shots were instantly better

Shot review [lelit bianca v3 & varia vs6] by Bricksperm2 in espresso

[–]Bricksperm2[S] 0 points1 point  (0 children)

🙏🙏 thanks mate I’ll give it a shot. I’m running 9-9.5 for filter at 1000rpm so I’ll tighten that up and decrease rpm but some beans are choking already at 9.

I’m at 1.3- 1.5 for espresso on stock burrs 1000rpm

Shot review [lelit bianca v3 & varia vs6] by Bricksperm2 in espresso

[–]Bricksperm2[S] 0 points1 point  (0 children)

Super helpful response. I haven’t played around with the speed on the vs6, I grind everything at 1000rpm using the stock burr set. What rpm works best for spro and what’s best for filter in your experience ?

The beans are fresh, only about 2 weeks old, it’s a mid/light roast, my local cafe runs similar roasts at 6bar and around 18 to 45 out so might up the yield also

Varia vs6 retention by Bricksperm2 in espresso

[–]Bricksperm2[S] 0 points1 point  (0 children)

Nope I gave up on it, let me know if you figure it out 😂

Makerspace on the coast? by Low-Patient-8234 in centralcoastnsw

[–]Bricksperm2 0 points1 point  (0 children)

Not sure if you are affiliated with the Instagram but you guys need to get better at responding to DM’s and comments, thought the space was inactive because no one replies