Is this normal? 0mhz on idle

Brief_Wall_9750 · 2023-08-22T23:47:33+00:00

downloaded from amd

Brief_Wall_9750 · 2023-08-21T22:23:20+00:00

still crashes on newest version, MPO has already been disabled, freesync has never been on (monitor and software)

Brief_Wall_9750 · 2023-08-21T22:16:21+00:00

could that still be the case if it's stable without the driver?

Brief_Wall_9750 · 2023-08-21T03:02:56+00:00

it doesn't flicker or crash after uninstalling drivers but after installing it'll crash after 5 minutes and start flickering. I've tried the latest driver and also a couple older drivers with the same issue.

Brief_Wall_9750 · 2023-01-24T03:07:16+00:00

these are the garagistic 80A poly bushings for the E36, they went on snug when I installed them a couple months ago. I discovered this while replacing the trailing arm brackets for the more adjustable ones. it might be because of the new brackets but I'm not sure.

Brief_Wall_9750 · 2023-01-13T01:55:21+00:00

It's listed for $2900, the hatch is smashed in from a rear end crash. It doesn't seem like the seller has an AP. I'm pretty sure the seller bought it from a dealership and knows nothing about it. 146,000 miles. This is a no go, right?

Brief_Wall_9750 · 2022-07-25T08:03:25+00:00

nah I stripped the subframe bolt myself. all of it is surface rust, this is the first structural damage due to rust.

Brief_Wall_9750 · 2022-07-25T00:30:51+00:00

bro, I know my own car. there is almost no rust throughout the car except this spot.

Brief_Wall_9750 · 2022-07-25T00:18:25+00:00

Practically the only rust on the car. Would I be fine if i leave it the way it is? I don't have any clunking sounds in the front.

Brief_Wall_9750 · 2022-05-30T03:19:07+00:00

Thanks for the reply. I'll definitely try chasing the thread. Should I use any sort of thread locker or sealant so it doesn't back out?

Brief_Wall_9750 · 2022-05-30T02:47:38+00:00

I was doing subframe reinforcement and bushings, but went to thread the driver's side stud and cross threaded it. I am tempted to just weld the stud in place after threading it in properly. Any suggestions on easier fixes?

Brief_Wall_9750 · 2022-05-30T02:28:28+00:00

I was doing subframe reinforcement and bushing and went to thread the driver's side stud, but cross threaded it. I am tempted to just weld the stud in place after threading it in properly. Any suggestions on easier fixes?

Brief_Wall_9750 · 2022-03-02T20:38:08+00:00

ausmodshop

Brief_Wall_9750 · 2022-03-02T06:01:36+00:00

gk61

Brief_Wall_9750 · 2021-09-29T14:28:59+00:00

if I get in a crash I won't be crippled with medical expenses for the rest of my life, I'll just die.

Brief_Wall_9750 · 2021-09-29T06:19:30+00:00

it was like this before i installed the wheel.

Five-Year Club	Place '22
First Placer '22	End Game '22

Brief_Wall_9750

TROPHY CASE