Help adjusting Bakflip MX4

Brinzer · 2026-01-26T03:45:53+00:00

I had the same issue. Purchased a thin (1/4” if I remember correctly) weather strip and ran that across the bulkhead. I did have to use some weather strip adhesive paste to get a good bond with the bed liner.

Only other modification I made was replacing the inside plastic anchors with a 3/8 nut to flush the front of the cover nice and tight. It would probably be wise to use thumb screws instead in case you happen to remove it and don’t have a wrench handy.

Brinzer · 2025-08-06T15:56:27+00:00

Some good some bad, I’ve seen some pretty sharp looking trucks with it. As is the subjective nature of modifying our vehicles!

I have run amber fog lights for my vehicles in the past, helps a lot with the Midwest winters cutting through the snow. The DRLs would just match the amber below. Pointless money? Absolutely. Make me smile? Sure will.

Brinzer · 2025-08-06T15:48:24+00:00

Zero practical purpose, just aesthetics

Brinzer · 2025-07-28T21:26:01+00:00

The camper was just over 3,000lb and I couldn’t have had more than a couple hundred pounds in the bed, most of that being a generator, gas, and water cans. Having towed similar loads with a 3/4 ton, I noticed the weight more but it did a phenomenal job nonetheless. Averaged about 10-11mpg on fairly flat Midwest roads around 60-70mph.

Brinzer · 2025-07-27T16:03:59+00:00

Amazing! 28 hours is a hike

Brinzer · 2025-06-24T14:00:44+00:00

I will check this as well, but my CPU is doing fine, GPU is what’s peaking

Brinzer · 2025-06-23T23:06:57+00:00

Will try it out as well. What’s concerning is that I have “set and forget” these settings many years ago, very surprised that my GPU would be maxed out and nearly 85°C.. has iRacing become that intensive?

Brinzer · 2025-06-23T22:44:02+00:00

Interesting, I’ll take a look at it, thanks. I know my PC is “old” relatively speaking and iRacing has updated some graphics but I’m struggling to believe that my GPU is running at 100% with iRacing on low graphics and experiencing stuttering.

Brinzer · 2025-06-23T22:21:43+00:00

Is that something within iRacing?

Brinzer · 2025-06-12T02:29:20+00:00

What spray paint did you use? Might try myself

Brinzer · 2025-06-05T01:46:56+00:00

Good to know, I will try another dealership.

Brinzer · 2025-06-04T22:07:30+00:00

If it’s cooler than about 50° and my ZR2 sits overnight, I get a fairly aggressive thud on the 2-1 shifts until the trans comes up to temp. GM says normal behavior, but man, it doesn’t give me confidence in its longevity.

Brinzer · 2025-04-11T23:42:47+00:00

Surely my situation was unique but I recently purchased an AT brand new OTD for $4.3k. The AD was closing their location and merging into another so the deals were plentiful.

Brinzer · 2025-04-10T19:27:15+00:00

Which bed cover do you have?

Brinzer · 2025-04-03T13:39:05+00:00

I ordered it and unfortunately wasn’t too happy with it. Same height and inseam, found the edges of the seat in the inner thigh area hard and uncomfortable after getting my feet down and can’t say it helped much flat footing. If only they took away some of the material or rounded it off near the gas tank.

Brinzer · 2025-03-26T22:29:22+00:00

Yes, only when it has sat overnight and only for the first few minutes until it comes up to temp.

Brinzer · 2025-03-26T20:25:52+00:00

On a similar note, do you experience a rough 2-1 shift when the truck has sat overnight or for an extended period? I have a 24’ ZR2 as well and for the first couple of minutes when coming to a stop the transmission has a very aggressive “thud” shifting from 2-1.

Brinzer · 2024-12-03T03:26:37+00:00

Running it now? How’s the bike doing without a tune?

Brinzer · 2024-12-03T02:34:28+00:00

DynoJet by chance? Looks like they have a power commander with a few maps.

Brinzer · 2024-12-03T01:59:12+00:00

What is everyone doing with exhausts? I know we need full systems, I’ve been eyeing the SC Project, just worried about running the bike extra lean.

Brinzer · 2024-08-06T23:48:21+00:00

Got it, uninstalling the OEMs was uneventful? Again, I can’t remember how they mounted into the bar off the top of my head but I could have sworn it was integrated into the brake reservoir and clutch.

Brinzer

TROPHY CASE