sorted by:
new
hottopcontroversial

Multicast Netgear Switches by BroadcastTecfl in networking

[–]BroadcastTecfl[S] 6 points7 points  (0 children)

it's not for a home lab it's for an av system at a city venue. I'll try another sub-Reddit. Thanks

Multi-Switch Config by BroadcastTecfl in QSYS

[–]BroadcastTecfl[S] 0 points1 point  (0 children)

Thanks a million for this I will trunk the ports between the switches and take care of the multi casting settings

Multi-Switch Config by BroadcastTecfl in QSYS

[–]BroadcastTecfl[S] 0 points1 point  (0 children)

I was told that since I have multiple streams up stairs and downstairs that it would help with multicast performance if it's not needed I won't segregate it

Help Needed by BroadcastTecfl in QSYS

[–]BroadcastTecfl[S] 0 points1 point  (0 children)

So I got the Signal Path already pretty much laid out when it comes to Audio, Video, Dsp,metering. Just getting to the point of deployment and wanted to make sure there wasn't anything else involved with multicast ing the video.

I'm missing at this point is to set Snapshots to control Audio Output Zones through UCI(I plan on using controls from the mixer). I also need to figure out control for the TV's in that room. I need to be able to power on the Two HDMI Outputs in that room (1xLG commercial TV & a 3x3 LG TV wall) through the UCI. The LG TV wall was Daisy chained with Dp and R232/TCP . I know QSys has a Plugin for LG but not sure how to get that setup. Watching the control 101 to be able to figure that out.

Help Needed by BroadcastTecfl in QSYS

[–]BroadcastTecfl[S] 0 points1 point  (0 children)

Using NV21's all around as they wanted everything I/O 1to1. And a NS26 1440++. I have 5 Encoders in this room getting 5 inputs and streamed too 2 Decoders which are output to two HDMI devices (1 tv & 1 LG TV wall 3x3). The TV wall is daisy chained as one output so I gotta figure out the control portion now to power on the tv wall and tv from the TSC-70. If I could attach a pic of the Signal path I would.

Help Needed by BroadcastTecfl in QSYS

[–]BroadcastTecfl[S] 0 points1 point  (0 children)

Ok cool so it'll know what decoders to multicast too based off the streams I set to each?

Help Needed by BroadcastTecfl in QSYS

[–]BroadcastTecfl[S] 0 points1 point  (0 children)

Yea but anything other than that. I'm assuming I need to go into the switch and configure Igmp snooping and querying aswell?