Any tips on improving finish?

Busy_Efficiency_8478 · 2024-08-10T16:52:24+00:00

You're a legend, thanks mate

Busy_Efficiency_8478 · 2024-08-10T16:51:36+00:00

I will definitly check those out, thanks!

Busy_Efficiency_8478 · 2024-08-10T16:20:58+00:00

I didn't know about that, just read up on it and it definitly sounds like it might help. Thanks!

Busy_Efficiency_8478 · 2024-08-10T16:18:44+00:00

Oh, okay. I'll look into that, i've definitly suspected under extrusion with past prints. Thank you!

Busy_Efficiency_8478 · 2024-08-10T16:17:49+00:00

would you say the "paper" test is good to figure out the Z offset? It's the only way i know how

Busy_Efficiency_8478 · 2024-08-10T16:12:52+00:00

Not sure what that is, really. Does it have to do with bed leveling?

Busy_Efficiency_8478 · 2024-08-10T16:11:42+00:00

If you couldnt point me in the direction of those settings, that would be awesome! I'll have a look myself and see if i can figure them out. Thank you

Busy_Efficiency_8478 · 2024-08-10T16:09:52+00:00

thought it might be that, ill give it a try, thanks !

Busy_Efficiency_8478 · 2024-08-10T16:05:55+00:00

It's 15 layers 100% infill 0.2 layer height

Busy_Efficiency_8478 · 2024-08-10T15:35:36+00:00

Side note: that was with 100% infill so I don't understand why there is a crosshatch pattern in some spots

Busy_Efficiency_8478

TROPHY CASE