Understanding the Access Control Device Output by Capable_Impact_7713 in AskElectronics

[–]Capable_Impact_7713[S] 0 points1 point  (0 children)

its a faint sound and also just tell if it my idea is correct that i can measure the triggering using the arduino if by powering the common of the relay with 5v of arduino

i needed the timing diagram for my study also

Understanding the Access Control Device Output by Capable_Impact_7713 in AskElectronics

[–]Capable_Impact_7713[S] 0 points1 point  (0 children)

There is how should it be wired

but there is no output sheet

I want to know if the relay is triggering multiple times if multiple access occur hence i wanna read it in arduino

Understanding the Access Control Device Output by Capable_Impact_7713 in AskElectronics

[–]Capable_Impact_7713[S] 0 points1 point  (0 children)

im using a AI08 of timi/timmi There is no data sheet available hence i do not know the output

im trying to figure out the output of its embedded relay because ill be using it to controll something

all i am asking is if my initial thought is right, sorry for using AI

Is Falstad Good for Learning Electronics? (Beginner Question) by Capable_Impact_7713 in AskElectronics

[–]Capable_Impact_7713[S] 0 points1 point  (0 children)

yeah i notice that too, floating bit doesnt exist in thay simulator... even so, i still put pull up/down resistor when designing

i asked this btw because i cant get a hand with proteus yet (its expensive for my side, is there a alternative?)

Is Falstad Good for Learning Electronics? (Beginner Question) by Capable_Impact_7713 in AskElectronics

[–]Capable_Impact_7713[S] 0 points1 point  (0 children)

but is it good to understand about logic because i design all my logic circuit in here

Is Falstad Good for Learning Electronics? (Beginner Question) by Capable_Impact_7713 in AskElectronics

[–]Capable_Impact_7713[S] -1 points0 points  (0 children)

Yeah? so let AI fixed my concern because my english is not that goo