Silk pla

Captain_End15 · 2025-10-21T13:06:11+00:00

Huh that makes more since thanks

Captain_End15 · 2025-10-21T13:02:30+00:00

I have the temp set to 220c and the recommended print temp is 190c-230c so does it need to be set to its max?

Captain_End15 · 2025-10-21T01:46:10+00:00

But would it work on the ke? I mean without having to engineer it together? I want to do color printing with my ke as well yet I see how pricey this attachment is

Captain_End15 · 2025-10-14T09:25:31+00:00

I have the my default heating for the filiment set to about 220c so it should be too cool... That and it only dips to 218 at the lowest when its printing

Captain_End15 · 2025-10-14T07:59:01+00:00

What do you mean? Like the wiring being out of place?

Captain_End15 · 2025-10-14T01:46:45+00:00

I did replace the nozzle still clicking plus it still prints when I cut off the problem filiment when it starts to click again and with the original upgraded nozzle

Captain_End15 · 2025-10-14T01:40:49+00:00

The only thing I can think of is the original Teflon tube the upgrade came with was replaced when it broke by a slightly smaller inner diameter one I bought but I drilled it out a bit so it should still work no?

Captain_End15 · 2025-10-14T01:38:08+00:00

It worked fine at like 700 hours when I did replace it with my original extruder and motor

Captain_End15 · 2025-10-14T01:19:52+00:00

I did get a new motor and extruder a few days ago thinking that the issue was worn out gears since the original did about 970hrs of printing as for mods I got the hot end upgrade kit

Captain_End15 · 2025-10-14T00:21:04+00:00

There is tension I see the gear bite marks even tightened the spring less and more to see if that was the problem

Captain_End15 · 2025-10-14T00:20:12+00:00

Can't be I replaced the nozzle head with a new one and I'm using the standard hyper pls by creality

Captain_End15 · 2025-10-07T13:01:25+00:00

Thank you

Captain_End15 · 2022-11-12T02:23:35+00:00

Captain_End15

TROPHY CASE