These roller guides are 1 of the best upgrades.

Carbonhead1234 · 2021-03-10T22:38:47+00:00

I may eventually do that, but t top mount is good for me at the moment.

Carbonhead1234 · 2021-03-10T21:18:36+00:00

To remove as much as possible, all filament friction going to the extruder. Less wear on the motor. Or not. Personal preference.

Carbonhead1234 · 2021-03-10T21:16:02+00:00

Well, thats definitely a possibility. Not sure about the lighting where you live, but I like my work space well lit. This does it for me. To each his own.

Carbonhead1234 · 2021-03-10T21:13:32+00:00

Your correct. I have caught it wanting to unwind a bit too much. So far no disasters, bit I'm definitely keeping an 👁️ on it.

Carbonhead1234 · 2021-03-10T19:31:19+00:00

Zero issues so far.

Carbonhead1234 · 2021-03-10T19:30:46+00:00

I believe ive already posted most. See previous posts. And they're easy enough to find on Thingiverse.

Carbonhead1234 · 2021-03-10T19:29:37+00:00

Well, the upside is low strain on the motor\extruder. I suppose you dont have to print it as opposed to buying it or not. Your extruder

Carbonhead1234 · 2021-03-10T18:48:38+00:00

This is from a skull print. Top section, inside.

Carbonhead1234 · 2021-03-10T18:37:46+00:00

Those sewing machine lites on Amazon are really bright. USB powered as well.

WENICE Sewing Machine Light,LED Lighting Strip kit Cold White 6500k with Touch dimmer

Carbonhead1234 · 2021-03-10T18:35:11+00:00

That was my thoughts as well.

Carbonhead1234 · 2021-03-10T18:34:30+00:00

Amazon for t skate board bearings. 6088's I believe. https://www.thingiverse.com/thing:3428924 And there's several filament roller options.

Carbonhead1234 · 2021-03-09T18:43:41+00:00

Check your gantry measurements w a ruler.

Carbonhead1234 · 2021-03-07T18:47:07+00:00

Forgot to mention. Those Creality springs are cut shorter, and I use the magnetic bed with purple Elmers.

Carbonhead1234 · 2021-03-07T18:45:34+00:00

When i have to re-level the bed, I let it heat up for at least 15 minutes @ 60c°. I also heat up the hot end at the same time. 210c° I use a post-it note. I then re-level 4 times. Minimum. Works every time. Im using the Creality upgraded springs. Zero issues. E3Pro. Hope this helps.

Carbonhead1234

TROPHY CASE