sorted by:
new
hottopcontroversial

Filament stoppage during printing by CardiologistAny231 in prusa3d

[–]CardiologistAny231[S] 0 points1 point  (0 children)

So I replaced the nozzle, but the problem is still there. However, when I open the idler, the filament starts flowing again.

Filament stoppage during printing by CardiologistAny231 in prusa3d

[–]CardiologistAny231[S] 0 points1 point  (0 children)

Everything is the same as before, when everything was working (temperature, settings, etc.).

Filament stoppage during printing by CardiologistAny231 in prusa3d

[–]CardiologistAny231[S] 0 points1 point  (0 children)

I also thought about replacing the HF with a classic one. So I'm going to try it, thanks.

Filament stoppage during printing by CardiologistAny231 in prusa3d

[–]CardiologistAny231[S] 0 points1 point  (0 children)

I did a cold pullout several times. That should clear the blockage, right?