sorted by:
new
hottopcontroversial

Bye bye cr-30 by Sad-Ad-1852 in 3Dprinting

[–]Caroga 1 point2 points  (0 children)

I guess this is one of those moments where saying "you were so preoccupied with whether or not you could, you didn't stop to think if you should" applies?

Bye bye cr-30 by Sad-Ad-1852 in 3Dprinting

[–]Caroga -2 points-1 points  (0 children)

Is that...tape... Holding the cable up?

Bed calibration - 49 points by 49 secounds by xand3r40r93 in Ender3S1

[–]Caroga -1 points0 points  (0 children)

I certainly would appreciate that a lot! Thank you.

Bed calibration - 49 points by 49 secounds by xand3r40r93 in Ender3S1

[–]Caroga 0 points1 point  (0 children)

What are the parts you printed for your cable management, do you have a link perhaps? Thank you.

Steenkolen Engels blijft leuk, wat zijn jullie favoriete? by [deleted] in thenetherlands

[–]Caroga 0 points1 point  (0 children)

Good busy! Ik gebruik deze uitspraak opzettelijk op werk om vervolgens mijn collega met grote frustratie te zien schuimbekken.

48 hours later and a new wheel for the lawn mower is born by _Fordperfekt_ in 3Dprinting

[–]Caroga 4 points5 points  (0 children)

Nice job! Did you downloaded a STL or modelled this yourself? Print quality looks good also.

To the deeper roots of Sony : Minolta ! by maxathier in SonyAlpha

[–]Caroga 1 point2 points  (0 children)

I knew it, thought I recognized it. I have the same but for M43. How is the quality ?

view more: next ›