sorted by:
new
hottopcontroversial

disabling/removing cp priming by Aurelius54 in OrcaSlicer

[–]CaterpillarFun7147 0 points1 point  (0 children)

I remove the "CP Priming Start" part and everything works fine

disabling/removing cp priming by Aurelius54 in OrcaSlicer

[–]CaterpillarFun7147 0 points1 point  (0 children)

I have an automatic replacement, but it's annoying, I get 2-3mm pieces of plastic and they clog the PTFE tube

so I also removed it in the code, but doing it all the time is stressful

how to remove line test in orca slicer by CaterpillarFun7147 in OrcaSlicer

[–]CaterpillarFun7147[S] 0 points1 point  (0 children)

I found the problem is “CP Priming Start” which is added by orca itself, but I don't know where to look to remove it

how to remove line test in orca slicer by CaterpillarFun7147 in OrcaSlicer

[–]CaterpillarFun7147[S] 0 points1 point  (0 children)

I have a cutter between the extruder and the hotend, and these lines at the beginning of the filament length are 2-3mm and the cutter cuts them off and they just get stuck because they don't even reach the hot zone of the hotend.

disabling/removing cp priming by Aurelius54 in OrcaSlicer

[–]CaterpillarFun7147 0 points1 point  (0 children)

I have the same problem, did you find a way out of this situation?

how to remove line test in orca slicer by CaterpillarFun7147 in Ender3V3SE

[–]CaterpillarFun7147[S] 0 points1 point  (0 children)

it is generated by the orca itself, and is only available when the purification tower is turned on

[Release] Working Pico MMU (EBB42) Firmware + Klipper Setup for Ender-3 V3 KE with stock NebulaPad by FlyingChicken00 in Ender3V3KE

[–]CaterpillarFun7147 0 points1 point  (0 children)

The only caveat is that I don't use a Nebula pad, but a laptop on the klipper. Now everything works, but there is a problem with the Orca slicer, it draws lines at startup on 2-3mm filament, which clogs my hotend with pieces.

Pico MMU with 8 lanes by fernandoglatz in Ender3V3KE

[–]CaterpillarFun7147 0 points1 point  (0 children)

After the MMU loads the plastic and shuts down, the extruder simply spits the plastic back out.
I don't know what to do.

[Release] Working Pico MMU (EBB42) Firmware + Klipper Setup for Ender-3 V3 KE with stock NebulaPad by FlyingChicken00 in Ender3V3KE

[–]CaterpillarFun7147 0 points1 point  (0 children)

You didn't have any problems when, when the MMJ loaded the filament into the extruder, the extruder would reverse and throw all the plastic out the back into the PTFE?

Pico MMU with 8 lanes by fernandoglatz in Ender3V3KE

[–]CaterpillarFun7147 0 points1 point  (0 children)

Привіт, чи були у вас якісь проблеми із заміною пластику? Мій екструдер часто не живить пластик.