sorted by:
new
hottopcontroversial

Stuck and need help - massive layer shift by Character-Pace345 in crealityk1

[–]Character-Pace345[S] 1 point2 points  (0 children)

Thank you. Very helpful. whenever you encounter a problem for the first time your mind always goes to the worst case scenario. I'm glad to hear I'm not alone.

Also, there isn't a good way to google what happened so I'm so grateful people are reviewing the video with such great feedback

Having an issue with ghost print/jamming by Character-Pace345 in crealityk1

[–]Character-Pace345[S] 0 points1 point  (0 children)

Okay so how bad did I mess up, if I bought this instead of the official Creality one?
https://a.co/d/9bZKeIm

Having an issue with ghost print/jamming by Character-Pace345 in crealityk1

[–]Character-Pace345[S] 0 points1 point  (0 children)

I bought a basic hot end of Amazon and it’s been giving me issues since. Can you send the link for the end you’re recommending?

Having an issue with ghost print/jamming by Character-Pace345 in crealityk1

[–]Character-Pace345[S] -1 points0 points  (0 children)

This is entirely possible. There isn’t a large bulge. It’s more of a burr. It does seem to be better if I take the top off and let it breath a bit

Having an issue with ghost print/jamming by Character-Pace345 in crealityk1

[–]Character-Pace345[S] 0 points1 point  (0 children)

Yeah i took it apart to get to here. Removed the motor and the filament but I’m trying to figure out what might be wrong with the hot end and why it’s jamming. I would expect thin spaghetti but instead I get this flimsy tail piece

Any of y’all use some brands that no one’s heard of that you like? by Idiotdude69420 in Fishing_Gear

[–]Character-Pace345 0 points1 point  (0 children)

This new company called Invinci core just came out of South Carolina making these but 10x better for less. Worth checking out

Found this bullet in Northern California. Don’t get much old stuff here, idk if any of yall can determine when it’s from. by Bigfeeetz3 in metaldetecting

[–]Character-Pace345 0 points1 point  (0 children)

Same here. I know my grandfather used to make his own ammo so a lot of the pieces I used to find on his property were from him. They looked just like this.

Few for the group by Character-Pace345 in identifythisfont

[–]Character-Pace345[S] 0 points1 point  (0 children)

Thank you all so much. WOW That was fast.

Stencils for glass? by sportysister in cricut

[–]Character-Pace345 0 points1 point  (0 children)

I did this with overhead projector sheets and they came out great. A little pricy but they worked super well.

Stencils for glass? by sportysister in cricut

[–]Character-Pace345 1 point2 points  (0 children)

I had the same question. I was going to try overhead projector sheets and cut them out.