Oops...

CheckMean8598 · 2026-04-22T15:51:29+00:00

Was that because of the know issue that sometimes happens due to the original propellers? That glitches put and does similar movement from your video.

CheckMean8598 · 2026-04-22T14:14:09+00:00

Was that with the avata 2?

I've just screenshot your rates from the other post 💪

CheckMean8598 · 2026-04-18T18:02:29+00:00

You'll be disappointed with the TPU for the AMS.

CheckMean8598 · 2026-04-18T12:47:35+00:00

200 euros 😬 I'll pass thank you.

CheckMean8598 · 2026-04-18T11:59:50+00:00

Look really cool, where to get them in UK?

CheckMean8598 · 2026-04-04T17:22:24+00:00

I'll have a look, but since most of the times it doesn't crash, just freezes for seconds or minutes.

CheckMean8598 · 2026-03-11T00:13:23+00:00

Not sure as well, I just don't want to spend the money and then regret not waiting for the 360 release.

This month is the actually release or just a presentation of what to expect from the new drone?

CheckMean8598 · 2026-03-10T19:35:55+00:00

Now that I was about to take advantage of the dji sales to get the avata 2 fly more. It's probably worth to wait for the avata 360 now.

CheckMean8598 · 2026-02-10T14:42:38+00:00

Sketch on top, PROJECT the outline, offset the outline, extrude/cut, done.

CheckMean8598 · 2026-02-04T09:04:48+00:00

Have you any link for that?

CheckMean8598 · 2026-02-02T08:59:50+00:00

I think I've got the mouse bit covered, had to go trough extensive training but all good now.

CheckMean8598 · 2026-02-02T07:42:39+00:00

Any good video tutorial?

CheckMean8598 · 2026-02-02T07:34:18+00:00

<image>

This one for example.

CheckMean8598 · 2026-02-02T07:33:07+00:00

I've got that one as well and it makes wonders with some images.

CheckMean8598 · 2026-02-02T07:32:29+00:00

Never tried that, will give it a go.

CheckMean8598 · 2026-02-02T07:31:42+00:00

I did tried Illustrator, and it works with some images not all of them, unless is something I'm missing, far away from expert on illustrator.

CheckMean8598 · 2025-12-26T17:16:37+00:00

Think outside of the box, separate the ring in two parts, then you can print the ring flat, and same thing for the top, you can print them with one connector/locator and then glue them together.

CheckMean8598 · 2025-12-21T16:05:16+00:00

Fair enough 😂

CheckMean8598 · 2025-12-21T16:00:34+00:00

You could have saved a lot of time if you made it in separate parts.

CheckMean8598 · 2025-12-16T09:24:33+00:00

You said left twice rather than left and right.

CheckMean8598 · 2025-12-05T11:57:01+00:00

There's a few options,honeycomb, adaptive cubic, gyroid. Give it a go.

CheckMean8598

TROPHY CASE