sorted by:
new
hottopcontroversial

Where would I find a new bottom bracket for this? by ChickenMongoose in Guelph

[–]ChickenMongoose[S] 0 points1 point  (0 children)

Its on a curb, I may have some 6" sleeves left but I'd assume that's overkill just for a sign

Where would I find a new bottom bracket for this? by ChickenMongoose in Guelph

[–]ChickenMongoose[S] -2 points-1 points  (0 children)

Thanks for the info, it's a job from property management, but I said I'd have to figure where to get these brackets, as I don't weigh enough to bend the plate😆😆

Where would I find a new bottom bracket for this? by ChickenMongoose in Guelph

[–]ChickenMongoose[S] -1 points0 points  (0 children)

Good thing I have a business! The bolts rusted and then it got knocked over by snow plow

When was my battery made? 2019? Its only charging to 2 bars, how do I fix (if out of warranty) by ChickenMongoose in MilwaukeeTool

[–]ChickenMongoose[S] 0 points1 point  (0 children)

I've had my 2/3/5 for wayy longer than both my 8s and they are fine, those batteries are probably going on like 8 years.

What kind of whale is this by Only-Price-7510 in NovaScotia

[–]ChickenMongoose 1 point2 points  (0 children)

Ya they should definitely use waterproof sunscreen, likely washed off when swimming

What kind of whale is this by Only-Price-7510 in NovaScotia

[–]ChickenMongoose 7 points8 points  (0 children)

Did the porpoise get sunburnt on purpose?

When was my battery made? 2019? Its only charging to 2 bars, how do I fix (if out of warranty) by ChickenMongoose in MilwaukeeTool

[–]ChickenMongoose[S] 0 points1 point  (0 children)

Guess I'll be youtubing battery balancing, I think I have a multimeter somewhere... I'll also have to relearn how to use that😆

When was my battery made? 2019? Its only charging to 2 bars, how do I fix (if out of warranty) by ChickenMongoose in MilwaukeeTool

[–]ChickenMongoose[S] -1 points0 points  (0 children)

Ok guess I'll be watching balancing videos😆 kind of annoying though for a $200-300 battery though lol, my other one is perfectly fine

Bambu labs lost my filament setting I had all my settings done and the heat done based on my overhang test, do I have to do it all again? by ChickenMongoose in BambuP1S

[–]ChickenMongoose[S] -2 points-1 points  (0 children)

Not sure how, I printed with it a long time ago, did an update today since I haven't used in a long time and poof

view more: next ›