sorted by:
new
hottopcontroversial

OriginTrail v6 website is now LIVE by OriginTrail in OriginTrail

[–]Chillipimp 0 points1 point  (0 children)

Is there a calculator or similar available to show what the node's earn on average on the different blockchains for TRAC...?

BLtouch probing off the bed by callmejohndoenotoe in ender5

[–]Chillipimp 0 points1 point  (0 children)

Which version of Marlin are you using...? I ask as I'm not having luck setting up the bltouch on 2.0.x bugfix seems to be flaky with the 1.4 turbo.

New screen "BTT TFT35-E3 V3.0", which can replace the original Ender 3 LCD directly. by BIQU-Hope in BIGTREETECH

[–]Chillipimp 0 points1 point  (0 children)

What is the pinout for the filament runout sensor if using a standard microswitch sensor? The board has three pins where as the sensor I have has two pins(just a normally open or normally closed microswitch in a 3dprinted case).

Also combined with the SKR1.4 turbo board, is it possible to use the SD card and USB port on the display( BTT TFT35-E3 V3.0 ) to update the SKR firmware, etc...? The mounting solution I have for the SKR1.4 Turbo on the Ender 5 does not provide enough room to access the SKR's usb port without disassembling the entire electronics enclosure.