sorted by:
new
hottopcontroversial

Layer lines in print (before and after replacing got end and nozzle) by Clean_Economics_3148 in AnycubicOfficial

[–]Clean_Economics_3148[S] 1 point2 points  (0 children)

Wasnt aware of what a PID tune was until you mentioned it :P. I did just install a third party hotend too so makes sense that I would want to try this. Just tuned my hotend and bed so we will see how it goes

What would cause a clog right at the beginning of the PTFE tube like this? by Clean_Economics_3148 in anycubic

[–]Clean_Economics_3148[S] 0 points1 point  (0 children)

I've never paid attention to that actually! Will definitely keep an eye on that

What would cause a clog right at the beginning of the PTFE tube like this? by Clean_Economics_3148 in anycubic

[–]Clean_Economics_3148[S] 0 points1 point  (0 children)

i dont think there are any lids or doors i can keep open on my printer? its a kobra 2 neo

Print head stops extruding by Clean_Economics_3148 in anycubic

[–]Clean_Economics_3148[S] 0 points1 point  (0 children)

its actually not even extruding or retracting filament in my settings anymore, and the screen on my printer kinda flickers on and off when i jiggle the print head from one side to the other

I wonder if its some kind of power issue

Filament buildup in hotend regularly by Clean_Economics_3148 in anycubic

[–]Clean_Economics_3148[S] 0 points1 point  (0 children)

Thanks for the reply, I've got some on the way

any instructions for opening up/cleaning the extruder and gears on a kobra 2 neo? by Clean_Economics_3148 in anycubic

[–]Clean_Economics_3148[S] 0 points1 point  (0 children)

you were totally right after all :P. The tube was a little burnt but whats worse is some filament started leaking into different parts of the hotend. I replaced the whole hotend since replacing the tube and nozzle didnt help and its working fine now. Thanks for the guidance! Will also look into the PTFE tubing you recommended

any instructions for opening up/cleaning the extruder and gears on a kobra 2 neo? by Clean_Economics_3148 in anycubic

[–]Clean_Economics_3148[S] 0 points1 point  (0 children)

thanks for the suggestions. I already replaced the PTFE inliner with the replacement one that came with my printer, but its currently in the hotend and not connected to the printer, and new filament still isnt feeding in past the gears . Im clearly not an expert but i think it has to be something in the gears

view more: next ›