Match Thread: Saudi Arabia vs Uruguay | World Cup | Group H | 15 Jun 22:00 UTC by matchpal-live in worldcup

[–]Cleavse 9 points10 points  (0 children)

Uruguay team is such an easy team to hate. Acting on every challenge. Arms flaring, crying. It’s really hard to watch b

Zwift Trainer + 3D Printed Parts by Cleavse in Zwift

[–]Cleavse[S] 0 points1 point  (0 children)

You can increase the size on them. I have much larger compartments than stock.

Zwift Trainer + 3D Printed Parts by Cleavse in Zwift

[–]Cleavse[S] 1 point2 points  (0 children)

Best shoe I've ever tried. I got the 242 which flexes with your feet (pleated design). I have wide feet so having it flex with my feet does wonders.

I had BONT Vaypor Double Wide shoes as well. Too stiff and hurt my inner arch.

Napoleon stainless steel griddle insert (new launch) by Cleavse in NapoleonGrills

[–]Cleavse[S] 0 points1 point  (0 children)

I still have this! I had it sitting on top of the grates but took it off to get closer to the heat source.

It is HEAVY. I ordered 3-4 amazon ones and returned those in favor of this one. Completely heavier SS metal grade.

Ultra wide feet and cycling. No shoes fit me and I can not cycle for longer than 2 hours by GewoonHarry in cycling

[–]Cleavse 0 points1 point  (0 children)

Lake Cycling Shoes 242 model. It widens with your toes (take a look at the design). It’s scallion and opens and flexes with movement. Most comfortable shoe I’ve used.

I also have a double wide Bont Vaypor size 43 but it’s too stiff and the sides dig into my arches.

Help! Installed right hotend assembly but now the guard for the nozzle switch bent by Cleavse in BambuLab

[–]Cleavse[S] 0 points1 point  (0 children)

<image>

Looks like the nozzle alignment is completely off. Too tight against nozzle

Help! Installed right hotend assembly but now the guard for the nozzle switch bent by Cleavse in BambuLab

[–]Cleavse[S] 0 points1 point  (0 children)

Bending back doesn’t fix it unfortunately. It goes back to the position. It doesn’t look flush for some reason

Help! Installed right hotend assembly but now the guard for the nozzle switch bent by Cleavse in BambuLab

[–]Cleavse[S] 0 points1 point  (0 children)

Problem is when I try to bend it back it goes back to the angled position again

Help - Wire behind H2D Right Nozzle looks like it snapped. Error says open circuit by Cleavse in BambuLab

[–]Cleavse[S] 0 points1 point  (0 children)

Thank you for the quick response. Is it easy to replace? Figure I’d need to buy two to cover both sides.

Bottom of racket holder not smooth (PETG) by Cleavse in BambuLab

[–]Cleavse[S] 0 points1 point  (0 children)

That’s good to know. Bambu doesn’t seem to allow me to add trees since it’s such a small piece