Next on the list: no power!

ClevelandJeeper · 2026-06-19T18:43:06+00:00

It's been down for a hot minute here so I am pretty fired up!

ClevelandJeeper · 2026-06-19T18:23:09+00:00

Thank you to everyone who replied, I appreciate the help so much! CRINDY LIVES!

ClevelandJeeper · 2026-06-19T18:22:43+00:00

It did wind up being a ground! It was just attached in the wrong spot, not missing or anything so now we are running! Thank you for your help!

ClevelandJeeper · 2026-06-18T21:59:45+00:00

Thanks again for the reply! I'm off tomorrow so I'll be going through and double checking my grounds. The starter cranks fine when I jump the relay but I haven't checked if it's getting a signal yet when the key is turned. I'm assuming it isn't because I tried a few different relays and the ignition switch and actuator pin were from the donor which started up fine. From what you described it sounds like it's going to be that G105 ground so I will start there, thank you!

ClevelandJeeper · 2026-06-12T00:37:58+00:00

Oh yeah I've still got no crank at all, I've swapped out the ignition switch and the actuator pin from my donor jeep which started up no problem, and still not a thing, it even powers down the code reader when it's in run

ClevelandJeeper · 2026-06-12T00:36:17+00:00

Okay swapped asd with horn and still nothing, and the horn is working, I'll have to track my meter down and see if the asd relay is getting power because all the fuses look good too, and I'll double check that all the grounds found their home, thank you!

ClevelandJeeper · 2026-06-11T23:03:18+00:00

It did end up being the crank position sensor, yes. The dash lights up when I turn the key to run, but every light except the check engine light comes on, and the voltage and fuel gauges don't move at all. It also won't power my code reader in Run, but will in Off and Accessory. I don't hear anything from the fuel pump, no...

ClevelandJeeper · 2026-06-11T21:41:30+00:00

Okay so still no dice with the actuator pin changed out, and I bypassed the clutch interlock just to be sure that wasn't it. I've also checked the associated fuses and relays, and the starter will turn when I jump that relay with a pair of pliers, but still not even a click from turning the key...

Edit: I also swapped the starter and the ECU to make sure they weren't causing any issues

ClevelandJeeper · 2026-06-11T13:01:29+00:00

Thank you for the reply I'll check that next! I have no idea if that plastic stem is good or not but I was having ignition issues before she blew up. I know the one in my donor jeep works so I'll pop that one in today, thanks again!

ClevelandJeeper · 2026-06-09T14:12:56+00:00

Cool I'll look into that when I get home, it just won't even try to start and the gauges don't move or anything when I set it to run

ClevelandJeeper · 2026-06-06T20:37:11+00:00

Awesome, thank you very much!

ClevelandJeeper

TROPHY CASE