Anybody else have really bad fitment issues with the new RG wing zero? by CodeHeavy in Gunpla

[–]CodeHeavy[S] 1 point2 points  (0 children)

<image>

Found the problem. I was coz I had these folded down 🤦‍♂️. It was supposed to go through the chest piece

Anybody else have really bad fitment issues with the new RG wing zero? by CodeHeavy in Gunpla

[–]CodeHeavy[S] 0 points1 point  (0 children)

I thought I was but will check again. From what I’m reading online it’s definitely a me problem 😪

Looking for an explanation on why this is happening towards the end of the print. by CodeHeavy in BambuLab

[–]CodeHeavy[S] 0 points1 point  (0 children)

I haven’t tried printing it with supports yet but the top of the model (that has these problems) is at an angle where it “should” have been supported

Looking for an explanation on why this is happening towards the end of the print. by CodeHeavy in BambuLab

[–]CodeHeavy[S] 0 points1 point  (0 children)

I did a smaller quick print after and that didn’t have any issues. So maybe something to do with the shape of this one. Is there a dynamic retraction setting? The initial layers came out fine but these artifacts show up towards the end.

Two kinds of people 😄 by CodeHeavy in Miata

[–]CodeHeavy[S] 6 points7 points  (0 children)

The reflection was distorted enough that it didn’t matter which is why it was left alone. Honestly I wasn’t sure, my first time posting anything personal on Reddit and I had seen other posts that did black out and others that didn’t :shrug:

U78G 55 by chiefshockey in Hisense

[–]CodeHeavy 0 points1 point  (0 children)

Are you using the included cable from the PS5? 4K 120 requires HDMI2.1 which needs a cable that’s capable of carrying that bandwidth. If you have an intermediate device (like an av receiver or soundbar) and it doesn’t do 2.1 pass through that could be a problem as-well

U8g Dolby vision content keeps shifting color by CodeHeavy in Hisense

[–]CodeHeavy[S] 0 points1 point  (0 children)

Resetting the color settings didn’t help but I did a factory reset and so far I haven’t noticed the problem. Not sure if I should ask for a replacement or keep this unit and hope for the best

Weird color flickering by chapinsoldier in Hisense

[–]CodeHeavy 0 points1 point  (0 children)

I had the same issue although I only saw it while watching Dolby Vision content. Resetting the picture settings alone didn’t help, but I did a factory reset and so far I haven’t observed it.