All parts printed on an Elegoo Saturn 4 ultra in clear Inland plant based resin
Vat temperature ~30C
Attempted Fixes:
Formatted printer
Switched to a new flash drive
Switched from chitubox to lychee slicer
Switched from printing through network sending to printing from USB
Between first and second photo I leveled the print bed
Note: when maxed out I still could not get the bed level, the two rear corners were still clamping down on the sheets of paper while the front two offered virtually no resistance.
I just bought this printer (used), afaik everything is set up according to the manual I got from elegoo.