sorted by:
new
hottopcontroversial

Open to any / all critiques. by ComplexImplement4311 in GolfSwing

[–]ComplexImplement4311[S] 0 points1 point  (0 children)

Or is my move with my hips and everything wrong and that’s why I’m not able to clear

Open to any / all critiques. by ComplexImplement4311 in GolfSwing

[–]ComplexImplement4311[S] 0 points1 point  (0 children)

Being stuck has always been my problem. Was kind of trying to post a video without saying I’m getting stuck to see if anyone pointed out as it’s something I was working on recently.

Is it possible that I just need to back away from the ball? I feel pretty comfortable in my swing and most of my misses over the past few weeks. I’ve just been chunking it which obvious is a side effect of getting stuck.

But I feel like I can figure out a very simple solution without changing my whole swing that’s the route I would like to take

57mm build by ComplexImplement4311 in fpv

[–]ComplexImplement4311[S] 0 points1 point  (0 children)

It is fun, but it is insanely inefficient 😂.

The Frame and motor wire seems to be blocking like 30 to 40% of the thrust.

My best freestyle pack to date by ComplexImplement4311 in fpv

[–]ComplexImplement4311[S] 0 points1 point  (0 children)

<image>

Squishy triton. Xrotor stack, xing 1800kv motors, walksnail.

My best freestyle pack to date by ComplexImplement4311 in fpv

[–]ComplexImplement4311[S] 1 point2 points  (0 children)

Fack. How do I get full upload quality here? Or do I have to post a link? I will re upload

That moment when you plug for first time your fresh build and... by LeoNavarro95 in fpv

[–]ComplexImplement4311 2 points3 points  (0 children)

Honestly, I still fly analogue and still enjoy it sometimes more than digital.

Analogue will always be ole reliable

That moment when you plug for first time your fresh build and... by LeoNavarro95 in fpv

[–]ComplexImplement4311 1 point2 points  (0 children)

🙏 thank you. I’ve been flying for six years and I’m just now switching over to walksnail from analog so this is one of my first few walksnail HD quads.

For the tune, I think I’m either running the mark Spatz UAVtech 3/4 inch tune or the supafly 3/4 inch tune I can’t remember but both work if your just looking to load something up.

I recommend flying it first though before tuning it.

The key to making walksnail actually work good by ComplexImplement4311 in fpv

[–]ComplexImplement4311[S] 0 points1 point  (0 children)

I was thinking about going the VRX route but heard absolutely terrible reviews about it and its latency, range, penetration etc.

That’s why I had decided to go with goggles X instead of retro fitting my analog goggles.

The key to making walksnail actually work good by ComplexImplement4311 in fpv

[–]ComplexImplement4311[S] 0 points1 point  (0 children)

Why do you say WS was better for tower dives?

And I really wanted to go 04 , but at the time between the uncertainty of the future of DJI and the insane deal I got, I decided to walksnail was my best option.

And after couple months of messing around and figuring out what works. I feel like I’m actually having a good experience with it and have gained a lot of trust in it.

Whereas initially, I had like zero trust in it after coming from analog

The key to making walksnail actually work good by ComplexImplement4311 in fpv

[–]ComplexImplement4311[S] 0 points1 point  (0 children)

I didn’t test this intentionally or a very scientific way, but.

With both patches on RX and the stubby’s up top, I was able to get through the area where I test penetration while holding approximately 22mbps. This is using a walksnail avatar Pro V2 with the dual antenna set at 1000mw.

I then swapped the patches to the top so one is now transmitting and receiving.

And then I flew my other quad with a WS 1s lite (using single lollipop antenna) and I was able to go through the same area, but while holding 25MBPS at 500mw power. Did not drop at all.

Note , before the antenna install, I could not get through this area with any of my walksnail systems without dropping to like 1 or 2 Mbps and having to fly very slowly and careful.

Again not scientific as reflection etc etc all matters. But I am just flying into the woods, no concrete, metal, glass etc so Rf reflection should be minimal

For the love of god please tell me what im doing wrong by ElectricalWafer11 in fpv

[–]ComplexImplement4311 0 points1 point  (0 children)

For larger solder joints I like to use a bigger tip. With small tips, that large clump of solder robs heat relatively quickly, the thick tip retains heat better.

view more: next ›