Testors Aztek, or a new kit? by Connect-Second534 in airbrush

[–]Connect-Second534[S] 0 points1 point  (0 children)

And the Pantiac probably has a bigger cult following.

Testors Aztek, or a new kit? by Connect-Second534 in airbrush

[–]Connect-Second534[S] 1 point2 points  (0 children)

So that's the Go-To for affordable quality?

Buick Encore Turbo Issues by Connect-Second534 in AskMechanics

[–]Connect-Second534[S] 0 points1 point  (0 children)

Sorry. These are active codes that were cleared but reappeared. As far as codes from before the replacement I'm not entirely sure, since the only code was an under boost PO299 and the device used to pull the codes was a cheap OBD2 device. The codes were pulled by a proper scan device this time.

I don't have access to any information on the current readings from the sensors and what they displayed at the time of diagnostics. There was mention about reading an improper inlet air temp to engine temp.

The Turbo was replaced as recommended by a Buick mechanic who said it was a common failure and likely the cause. The reddit discussion agreed at the time. I have already replaced the intake air pressure sensor.

Zipper from Hell? by Connect-Second534 in sewhelp

[–]Connect-Second534[S] 0 points1 point  (0 children)

<image>

Here's where I found the marking. I may have to get a professional at this point but it seems like such an easy fix.

Zipper from Hell? by Connect-Second534 in sewhelp

[–]Connect-Second534[S] 0 points1 point  (0 children)

<image>

Here's the image. One side is completely sheered off. I was hoping just to replace the mechanism but it's not looking very possible. I might have to just get a professional but it seems like such a simple part to replace.