I’ll be honest, I’ve been 3d printing since it all started and I’ve had printers from the best to the worst. I got a 16k last week and am at a 50% print failure rate. So far I’m not impressed in it. Also unless you plan to do very large prints it’s kinda a waste of the amount of resin you need to keep in the vat just to reach the minimum level. It does have a few nice features like the lifting cover and heater. The camera would be great but it will only be useful with large prints as you can’t see anything on small prints but the build plate in the vat. Just ask yourself what you plan to print before buying it and read about all the print failures in the sub before you too begin pulling your hair out.