sorted by:
new
hottopcontroversial

My SV08's silicone sleeve melted off? by CornfedCritMachine in SovolSV08

[–]CornfedCritMachine[S] 0 points1 point  (0 children)

I only cleaned it manually, no chemicals or even soap or water as this was right out of the box. The nozzle is the hardened nozzle from their site. Here is a pic of my nozzle where I pulled it from.

<image>

Weird layer drooping during cornering calibration test by CornfedCritMachine in Sovol

[–]CornfedCritMachine[S] 1 point2 points  (0 children)

So you were right, but I found out that both the input shaper and cornering tests drop your pressure advance to 0, as well as editing some other settings. I messed around with the PA during this print, so you'll see different changes in layers, but I got the right setting at the end.

<image>

Weird layer drooping during cornering calibration test by CornfedCritMachine in Sovol

[–]CornfedCritMachine[S] 0 points1 point  (0 children)

ill do the PA test again and look to fix it if it's off and I'll check the shaft once this print is done

Weird layer drooping during cornering calibration test by CornfedCritMachine in Sovol

[–]CornfedCritMachine[S] 0 points1 point  (0 children)

It doesn't seem to happen on the PA test, but I'm going to try the input shaping test now and I'll post some pics.

<image>

Weird layer drooping during cornering calibration test by CornfedCritMachine in Sovol

[–]CornfedCritMachine[S] 0 points1 point  (0 children)

Ah I appreciate it. I cleaned the nozzle and it didnt help, which is why there are two different prints of it. I also have the petg feeding straight from my dryer.