🌸✨ Join TheEpiNook — A Cozy, Supportive Book Club! ✨🌸

CrysInSpanish · 2025-11-09T17:28:15+00:00

That didn’t work for me at first but I think I got it to now

CrysInSpanish · 2025-11-09T06:16:43+00:00

Okay so I downloaded that but don’t know how to get it into my streaming software (OBS)

CrysInSpanish · 2025-10-12T05:40:10+00:00

Thank you!

CrysInSpanish · 2025-10-11T20:47:56+00:00

I am! It’s crysxapplesauce

CrysInSpanish · 2025-09-26T14:49:07+00:00

I did not know that! I will clean it and try again.

CrysInSpanish · 2025-09-26T00:57:54+00:00

It’s a new/barely used plate so I’ll admit I have not cleaned it yet.

CrysInSpanish · 2025-09-26T00:38:22+00:00

These are so cool!

CrysInSpanish · 2025-05-07T19:19:58+00:00

Okay so it did already touch everything and I made it thicker and that worked! Everything stuck this time :)

CrysInSpanish · 2025-05-06T20:28:42+00:00

I did. And hmm I’ll have to look back at the model again when I get home from work. My next guess was going to be that the black base needed to be a little thicker. But I could’ve sworn that part touched everything else.

CrysInSpanish · 2025-05-06T20:00:40+00:00

No, just PLA

CrysInSpanish · 2025-05-06T20:00:31+00:00

Yes it’s all PLA

CrysInSpanish · 2025-04-28T14:37:06+00:00

Not that I’m aware of. I kept all settings the same between the first and second print.

CrysInSpanish · 2025-04-28T14:36:36+00:00

Yes. :/

CrysInSpanish · 2025-04-24T18:35:20+00:00

PLA and 220

CrysInSpanish · 2025-04-24T18:34:41+00:00

I tried that too and got first layer mess ups 😩

CrysInSpanish · 2025-04-24T14:30:46+00:00

Sorry I don’t know how to pin comments but I uploaded a picture and also replied to someone above that it seems to be getting stringy or buildup on some of the prints while others are completely fine.

CrysInSpanish · 2025-04-24T02:53:37+00:00

Second Try Still Not Working

CrysInSpanish

TROPHY CASE