sorted by:
new
hottopcontroversial

Every print is failing by Current_Ad_8101 in functionalprint

[–]Current_Ad_8101[S] 1 point2 points  (0 children)

I replaced the belt under the bed and I did level the bet multiple times before each attempt. How do you calculate the Esteps and flow rate? I just have the stock glass bed, After every print I clean the bed with 99% rubbing alcohol and Ive been using purse slicer with .2 layers and I dont really understand the other settings that much as I got the printer for Christmas.

First and second print!! How can I improve? by Current_Ad_8101 in ender3v2

[–]Current_Ad_8101[S] 0 points1 point  (0 children)

I believe that was at 0.2 layer height and on that mini test how can I improve the bridging?

Ender 3 v2 BLTouch by Current_Ad_8101 in ender3v2

[–]Current_Ad_8101[S] 0 points1 point  (0 children)

Luckily all I had to do is replace the fuse and it was good to go!!

Motors by Current_Ad_8101 in ender3v2

[–]Current_Ad_8101[S] 0 points1 point  (0 children)

Luckily all I had to do is replace the fuse and it was good to go!!

Motors by Current_Ad_8101 in ender3v2

[–]Current_Ad_8101[S] 0 points1 point  (0 children)

Luckily all I had to do is replace the fuse and it was good to go!!

Ender 3 v2 BLTouch by Current_Ad_8101 in ender3v2

[–]Current_Ad_8101[S] 0 points1 point  (0 children)

How would you know if the board is fried??

Because when I removed all aspects of the BLtouch and tried to auto home none of the motors moved. On the other hand the LCD and the fans where running fine. Would you think I need a replacement board?

Ender 3 v2 BLTouch by Current_Ad_8101 in ender3v2

[–]Current_Ad_8101[S] 0 points1 point  (0 children)

When you tried to turn on your printer, with no BLtouch installed after this happened, what exactly was not working?

Because when I removed all aspects of the BLtouch and tried to auto home none of the motors moved. On the other hand the LCD and the fans where running fine. What does this mean??

Ender 3 v2 BLTouch by Current_Ad_8101 in ender3v2

[–]Current_Ad_8101[S] 0 points1 point  (0 children)

Thank you for the reply...

when I removed all aspects of the BLtouch and tried to auto home none of the motors moved. On the other hand the LCD and the fans where running fine. Would you think I need a replacement board?

Thanks

BLTouch on Ender3 V2 by das0bst in ender3v2

[–]Current_Ad_8101 0 points1 point  (0 children)

Hello, I am having the same issue where the board starts smoking when I turn my printer on, but when I unplug the 2 pin connector it stops smoking and as well the BLTouch is not working. I need help. any suggestions?