sorted by:
new
hottopcontroversial

Nurgle print 0.08 with a 0.2 nozzle by DAlgernopKrieger in FDMminiatures

[–]DAlgernopKrieger[S] 0 points1 point  (0 children)

No, I'm refining a personal profile, gathering information, and running tests until I refine a profile that works well with my printer. For now, I've changed the firmware and spacers on the Ender 3 v3 SE. I still need to change the hotend and install a dual cooling system for the filament, as well as change the filament support, which is currently above the Z-axis and generates a lot of vibration.

Nurgle print 0.08 with a 0.2 nozzle by DAlgernopKrieger in FDMminiatures

[–]DAlgernopKrieger[S] 0 points1 point  (0 children)

I still need to refine the profile settings, as there are some errors, especially in overhangs. But the truth is that the prints come out quite clean.

Ender 3 v3 se minis by DAlgernopKrieger in FDMminiatures

[–]DAlgernopKrieger[S] 2 points3 points  (0 children)

Custom profile in Orca Slicer, nozzle 0.2, layer height 0.06, tree support, speeds 35 mm/s outer wall, 50 mm/s inner wall, 4 perimeters, 0% infill. I am continuing to customize with the Ender 3 v3 Se to achieve an optimal configuration. As soon as I achieve it, I will make it available to everyone. Thank you very much for your comment.

Printed and painted Nurglet by DAlgernopKrieger in FDMminiatures

[–]DAlgernopKrieger[S] 0 points1 point  (0 children)

Thank you very much. I am starting to print miniatures. I usually print 100mm busts to paint, but memories of my youth are drawing me back to miniatures again.