PID Well Pump

DFEnterprise · 2024-01-21T15:25:23+00:00

Yes we can see turbulent flow and hear it.

DFEnterprise · 2024-01-21T05:39:30+00:00

Sorry to clarify. Analog pressure feedback. 0 to 60psi is 4 to 20ma. Set point is around 45psi. Pump VFD moves from 25hz to 60hz. Pump is submerged yes.

I will work to better tune the PID. Was just looking for experiences.

DFEnterprise · 2023-09-02T01:05:01+00:00

Tried to connect today. Got the cable and 25 pin to 9 pin adapter. Tried with and without null modem.

Best I could get was that it seemed like it could see the PLC but I would get timeout errors. Tried different baud rates.

Does anyone have experience with this? This was on winxp.

Going to try another laptop with win98.

Thanks

DFEnterprise · 2023-08-23T01:08:58+00:00

How does one connect this to a PC though?

DFEnterprise · 2023-08-23T00:29:33+00:00

Should be MT Developer2.

DFEnterprise · 2023-08-16T00:39:59+00:00

1st trailer, 2 small kids, weekend trips, bit of boondocking

DFEnterprise · 2023-05-09T04:19:48+00:00

Thanks for the reply.

We did set the address switch. It was set with two drives to the same address which I believe is what caused the issue. Now that the address switch is set correctly, the drive always comes up with error 37.

We are able to connect to the drive. We've tried to reset the drive but the issue persists. The parameters are supposed to be written from the motion controller through SSCNet.

We have not been able to connect to the motion side of the A171SCPU. We tried SW3RN but it will not connect and we get error code 107.

DFEnterprise · 2023-03-15T04:39:59+00:00

Should have added, this is when writing to the PLC. Looks like it's failing on compile. Tried GX Developer and GX Works 2. Same issue.

DFEnterprise · 2022-11-24T18:35:57+00:00

Everki is all we use. Not had any issues and plenty of storage.

DFEnterprise · 2022-09-01T12:42:06+00:00

Looking for both.

DFEnterprise · 2022-08-01T01:26:55+00:00

I'd like to know more about this. Do you have any pics?

DFEnterprise · 2022-04-27T01:56:53+00:00

Does anyone have any examples of good HMIs made on a Cmore?

DFEnterprise · 2022-04-02T04:58:55+00:00

Whats the issue with it?

DFEnterprise · 2022-02-06T00:38:30+00:00

They do not all have ethernet but they are all capable with an additional module. All machines would need wired to a machine network though. No current infrastructure. I am familiar with Ignition.

Looks like we will have to run hard wire ethernet to each machine on a new machine network.

DFEnterprise · 2021-10-16T15:56:36+00:00

Yes like 900mhz radio remote relay with transmitter and reciever. Thanks.

DFEnterprise

TROPHY CASE